20 Most Recent 2007 Dodge Charger SE Questions & Answers

The code means intake manifold control valve not any of these answers here.

ck brake pad condition replace if needed adjust parking brake cable

The first thing that must be done is to run a fault code test through the diagnostic connector with a fault coder reader.

Most cars have at back under on left or right side.

pick up new one then unplug and get wrench and unscrew old one and put in new one

The underhood connections can work by themselves...POS to POS, and NEG to NEG...sometimes dirty/weak connections do not allow the power to transfer fully from the underhood connections...if this is the case then you need to connect directly to the battery in trunk for full power charge...again POS to POS, and NEG to NEG...hope this helps

Battery? Charging system? Fan belts to alternator? Will it jump start? If starts with jump but stalls when jumper cable removed charging system is not working. No AAA or equal? Might be time to sign up.

No How would we do that ? How does one guess at noises over the internet ?

The oil light comes on when the car shuts off because there is no oil pressure. Make sure it has oil in it. If so take the car and get the codes pulled off the obd computer.

Can you hear the pump?

okay so contact the company who worked on your alarm if they cant fix it call another company to replace your alarm

You most likely broke a tie rod. You should see two points where your ball joints fit in. Probably still attached. You will need a ball joint removal kit, new tie rods, sweat and tears to get the old ones off but very doable.

bottom of block on driver side