2009 Citroen C3 1.4 - Answered Questions & Fixed issues
Citroen c3 2006 anti-theft
I had the same problem.when I used my main key my car wouldn't start and I got the message "anti theft
faulty". The key and the remote still unlocks and locks the doors and turns the lights
on/off but it just wouldn't start my car. I was able to start my C3 by using the spare key. The main key is still faulty and if used brings up the same message.
Citroen Relay van 2011 doors will not open
These locks don't work like traditional mechanical locks. It's just spinning as the lock and key are designed to do it if a wrong key is used. Original keys can become too worn to engage the mechanism inside it making it spin the same way. Try these basics.
Do you have a spare key you could try? Is there a key slot in the passenger side door you could try? Could you get to the driver's seat through the side or rear doors? Have you tried spraying a fine oil into the lock to lubricate it.
*NOTE* Do NOT use WD40 as it is not an oil. I would suggest something like GT85 or 3in1 spray.
How to replace plus wire on Citroen c8 diesel?
Disconnect your battery!
Remove the old wite from the battery supply end to the far end.
Replace it in the reverse order connecting the battery supply end last.
Reconnect your battery.
How do i remove control panel on a citroen c4 2016
To remove the control panel on a Citroen C4 2016, you'll need to follow a series of steps. Please note that working on the electrical components of a vehicle can be complex, and it's important to exercise caution and disconnect the car's battery before attempting any removal. It's recommended to consult the vehicle's service manual or seek professional assistance if you're not familiar with car electronics. Here's a general guideline:
1. Disconnect the Battery:
Before working on any electrical components, disconnect the car's battery to prevent any accidental electrical shorts.
2. Remove the Trim Panels:
The control panel is typically located behind the dashboard trim panels. To access it, you'll need to remove these panels. Carefully use a panel removal tool or a flat-head screwdriver to pry off the trim panel. Be gentle to avoid damaging the clips or the panel itself.
3. Unclip the Control Panel:
Once you have access to the control panel, you'll need to unclip it from the dashboard. The control panel may be held in place by clips, screws, or a combination of both. Carefully remove any screws or clips holding it in place.
4. Disconnect Wiring Harness:
After unclipping the control panel, there will be a wiring harness connected to it. Carefully disconnect the wiring harness by pressing down on any locking tabs and pulling it out. Be cautious while doing this, as improper handling may damage the wiring or connectors.
5. Remove the Control Panel:
With the trim panel removed and the wiring disconnected, you should now be able to remove the control panel from its mounting location. Gently slide it out.
6. Installation:
To reinstall the control panel, follow the steps in reverse order. Reconnect the wiring harness, secure the control panel in its mounting location, and reattach the trim panels.
7. Reconnect the Battery:
Once you've completed the installation, reconnect the car's battery.
8. Test:
Citroen Relay central locking issue
well. why have only just one fob>?
the fobs die at 10 years old easy.
the buttons inside ,mine failed now 2times.
2015 to now. mine.
the buttons have switches in mine, gold plated
and the gold now looks like shot gun blasted. (under a microscope)
as in END OF LIFE worn out. all fobs do that.
or battery new is bad or battery in backwards
or battery clips bent or rusty
never have only one fob. (or land here x)
Heater on my Citroen dispatch is not working
folks out side UK have no clue what my51 plate
we use the VIN to learn what year it is. and engine,and what country sold to.
is dash heater blower dead? on even high? speed?
test 1 of 10 . or so.
test 2 does pcm scans show ect at 180 to 200f temp?
google 200f to C and get your answer.
test 2 do both fire wall hoses, to heater core feel super hot, hand flays off?
i not both the core is clogged
if all hoses water feel cool they are and thermostat bad or missing
Not finding what you are looking for?