20 Most Recent 2005 Chrysler Pacifica Touring Questions & Answers

Take the rubber hose loose at the nozzle, try the washer. if water comes out then the little hole in the nozzle is stopped up. Use a small needle or stickpin to clean it out while someone works the washer switch.

2005 Chrysler... | Answered on Nov 28, 2017

Usually, hoses pop off if the radiator/expansion tank cap is incorrect/broken. Find out if this "mechanic" changed the cap, if they did, get the old one back or get a replacement from the dealer. I have never gotten a dependable replacement from any parts stores. If they didn't change it, change it anyway and see what happens.

2005 Chrysler... | Answered on Mar 09, 2017

check tires --have rebalanced ,make sure proper air pressure ,also check brakes --then check front suspension tie rods /balljoints control arms c/v axles

2005 Chrysler... | Answered on Oct 04, 2016

I would need to hear what the noise was to diagnose this.

2005 Chrysler... | Answered on Sep 24, 2016

Possibilities are brake switch, fuse, or grounds. Since all three are out. Grounds are usually on the drivers side attached to the frame by the left tail light assembly. I would recheck the fuse if you didn't pull it out and look at it. Corrosion can cause the lights not to work, but the fuse is good.

2005 Chrysler... | Answered on Jul 20, 2016

code p 0522 refers to engine oil pressure sensor/switch---low voltage === causes --wiring short to ground ---engine oil pressure sensor/switch---ECM
any reference to oil pressure warnings should be taken seriously as a destroyed engine is a result of inaction
first get it to an accredited service shop that handles your make of vehicle and have the oil pressure checked with a mechanical gauge
if it not a pump/ oil level problem , replace the sensor

2005 Chrysler... | Answered on Apr 20, 2016

If oil level is okay and the engine has pressure like no knocking the sending unit is bad. The dealer will charge about 85 to change it don't even try to do it yourself. It took a garage 6 hours to change it. It is in a bad spot and unless you want to rip the connector of it and hope it stays on the new one, it is easy to do . If you want it done right take it to the dealer


2005 Chrysler... | Answered on Jul 14, 2015

It shouldn't need either with only 69k. Odds are you have a break system problem. Check that first at a competent brake shop or your dealer. Brakes are an important safty system and repair should not be delayed.

2005 Chrysler... | Answered on Jul 05, 2015

There are two fans on for air and one to keep the engine cool the engine one is not working so that wire was the ground or the power wire and needs to be fixed. The wires to both fans go to the same area near the bottom of the battery area. Follow those wires and you will find the broken one and splice a new wire in

2005 Chrysler... | Answered on Jun 08, 2015

The parts-store gave you the wrong part. If you still have it, take the old part with you to the parts store. Just match it with the new one before you pay for it.

As for the traction-control matter, the difference has little to do with the master cylinder. In traction control, a computer and wheel-mounted sensors keep the wheels from skidding by turning the hydrolic pressure on and off to the individual wheels according to which one is or is not skidding.

2005 Chrysler... | Answered on Mar 08, 2015

That can be a number of things. I just had a car with that noise and it was a broken motor mount. This caused the engine to move when you push the gas pedal, the fan hit the radiator shoud and that was the noise. I can't really diagnose the problem, unless I am there to witness the noise.

2005 Chrysler... | Answered on Feb 05, 2015

usealy thats a bulb in the panel

2005 Chrysler... | Answered on Nov 29, 2014

Is this the only light that is out? If so the bulb has failed. You would have to change the bulb. Pop the plastic cover over your instrument cluster, Unscrew the instrument cluster (4 screws) , pull towards yourself .The bulb is behind the temperature gauge. There you will find a holder of the bulb, turn left or right to unscrew remove and change the bulb. I believe it to be 194. When installing bulb wipe clean with cloth and don't touch. Skin oil tends to make for short life. Install bulb and go in reverse till all is together. GOOD LUCK FRIEND.

2005 Chrysler... | Answered on Nov 12, 2014

Not finding what you are looking for?
2005 Chrysler Pacifica Touring Logo

75 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pacifica Chrysler

  • Pacifica Chrysler

Most Popular Question

2005 pacifica touring started making

  • Cars & Trucks