20 Most Recent 2007 Chrysler 300 Questions & Answers


Limp mode , transmission . have checked for DTC'S - diagnostic trouble codes . This would point in a diagnostic direction .

2007 Chrysler... | Answered on Feb 19, 2017


Pull the negative cable off the battery for 30 minutes will reset keep alive memory. Question? Why do you want/need to do this? I only do this for bad emission problems. But the problems have to be fixed first.

2007 Chrysler... | Answered on Nov 13, 2016


Built into the PCM. Could be the tipm/fuse panel though. If your just throwing money at it. Go with the tipm first. I have replaced many of them.

2007 Chrysler... | Answered on Nov 12, 2016


Well, since no one is forthcoming with this information, I found out today that the allen wrench on the caliper pins is apparently 7 mm, a size not usually offered on most sets. If you have information to the contrary, let me know. I had the guy at the parts store pull a hardware kit and that was the size. Hope this helps someone. Locksmith Hamburg Ny 24 Hour Locksmith 716 249 2944 in Hamburg Ny
26249897-dnc2e1izs3stmwduc0sbwiqp-1-0.jpg

2007 Chrysler... | Answered on Aug 28, 2016


Anywhere there could be moisture or relays fail periodically.

If you need further help, reach me via phone at https://www.6ya.com/expert/chris_b82b45c59bcf133d

2007 Chrysler... | Answered on Mar 10, 2016


Get an OBDII reader and connect to see what error codes you are getting. Limp mode can be caused by many different things including problems with the transmission.

2007 Chrysler... | Answered on Dec 19, 2015


What does the key have to do with the issue? You need to deactivate the anti theft mode. Your car manual should have this information readily available. OR ask your car dealer for the info.

2007 Chrysler... | Answered on Oct 28, 2015


check to make sure you haven't drop any change from your pockets in to it... i actually did this once and it ended up being an dime stuck in it

I’m happy to help further over the phone at https://www.6ya.com/expert/john_5260ce46f2f674cc

2007 Chrysler... | Answered on Aug 17, 2015


the speakers maybe blown out, there mite be a short in the system, the antenna maybe loose or have short in the connector, there a short in an electronic component in the radio, it also could be a grounding issue, when you hit a bump it looses it connection or the unit has short in the receiver and it cuts out the signal in the radio station, losing power some where, if i was you go to stereo shop or buy new radio, all the money you would spend looking or trying to repair would cost you a lot of money, troubleshooting, radio, speakers, wiring, shop supples, no warranty after wards,
good luck

2007 Chrysler... | Answered on Apr 21, 2015


Sounds like a corroded connection on the engine harness or it's melted/rodent chewed around the manifold.

2007 Chrysler... | Answered on Apr 16, 2015

Not finding what you are looking for?
2007 Chrysler 300 Logo

104 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Mike

Level 3 Expert

4369 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

300 Chrysler

  • 300 Chrysler

Most Popular Question

get key out ignition 2007 chrysler 300

  • Cars & Trucks
Loading...