2010 Buick Enclave - Answered Questions & Fixed issues
2010 buick enclave...need to know location of camshaft position sensor
I think some people (myself included) are confused between camshaft and crankshaft position sensors. I believe their are 4 camshaft position sensors in 2 banks, I’d like to know all these locations as I have p0014 and p0021 corresponding to both banks of CAM shaft sensors. Where are these locations please? I have 2009 Enclave also.
2/16/2019 4:47:19 AM •
2010 Buick...
•
Answered
on Feb 16, 2019
•
4,137 views
No defrost
Did you preform recalibration after replacement ? See if this works ,if not you'll need to take it to the dealer an have it done with factory scan tool .
Alternate Method (w/o Scan Tool)
- Clear all DTCs.
- Place the ignition switch to the OFF position.
- Install the HVAC actuator.
- Connect all previously disconnected components.
- Remove the HVAC/ECAS fuse for a minimum of 10 seconds.
- Install the HVAC/ECAS fuse.
- Start the vehicle.
- Wait 40 seconds for the HVAC control module to self-calibrate.
- Verify that no DTCs have set as current DTCs.
9/25/2016 8:48:38 PM •
2010 Buick...
•
Answered
on Sep 25, 2016
•
1,831 views
Car is overheating
Rust in the radiator, fan motor not coming on, stuck thermostat. Check all these places and you'll find the reason for overheating.
3/16/2016 5:23:21 AM •
2010 Buick...
•
Answered
on Mar 16, 2016
•
113 views
My 2010 buick enclave wont move out of park
Is there a button to one side of the shifter that you need to press first?
I have seen a button poking out the side of the top bar that needs to be pressed before the shift lever can be operated from Park.
3/31/2015 10:18:37 PM •
2010 Buick...
•
Answered
on Mar 31, 2015
•
651 views
Why do my dome lights not come on when door is open?
The dome light is on a separate fuse since the dome light is one of the few lights that are connected to the battery even if the key is off.
There are usually two relay/fuse boxes
One under the hood on the drivers side near the firewall.
The other place is under the dash to the left of the drivers knee.
Hope this helps.
3/6/2015 5:54:21 PM •
2010 Buick...
•
Answered
on Mar 06, 2015
•
900 views
Why do my dome lights not come on when doors are open?
The dome light is on a separate fuse since the dome light is one of the few lights that are connected to the battery even if the key is off.
There are usually two rely/fuse boxes
One under the hood on the drivers side near the firewall.
The other place is under the dash to the left of the drivers knee.
Hope this helps.
3/6/2015 5:52:37 PM •
2010 Buick...
•
Answered
on Mar 06, 2015
•
152 views
How do I replace rear tail light bulb?
between the light and the door opening in the black portion of the light you will see two small kinds square caps. gently remove those caps, now you will see two mounting screws that secure the light. You are off from here.
12/19/2014 9:59:00 AM •
2010 Buick...
•
Answered
on Dec 19, 2014
•
139 views
Remouving the side window
on the inside of the car their are screws that mount the mirror to your car. remove them to get the mirror off, then you can access the mirror mounting screws, in some cases the mirror will pop out of a post style plastic mount. check with the parts department of your dealer.
12/19/2014 9:24:27 AM •
2010 Buick...
•
Answered
on Dec 19, 2014
•
49 views
No crank on 2010 buick enclave , no ecm or tcm , abs communication
Sounds as if you may have failed to reconnect some wiring. If not, security system may need to be re-set. I don't know how to do that on your car, sorry. Are you absolutely sure you have a good battery connection? Clean all cables to battery and retry.
12/2/2014 5:53:15 PM •
2010 Buick...
•
Answered
on Dec 02, 2014
•
2,320 views
Not finding what you are looking for?