20 Most Recent
2016 Ford Fusion Questions & Answers
Why is the keyless entry pad flickering on my 2016 ford fusion
Bad wiring or loose wiring harness would be my first suggestion. Could even be the pad itself having issues. I am fairly sure that a code would come up. If you were to have your local auto parts store run a diagnostic. Depending on the year it's either ODBII or OBDIII. Also you should check the web for any "recalls" that might be relevant.
Hope this helped,
Jason
Where is the evaporative emission vent control valve located on a 16 ford fusion with the 2 liter turbo engine
I'm going to assume for simplicity's sake that you're talking about the evap canister purge solenoid, I've heard it called the vent control valve several times before, but technically we call it the evaporative canister purge solenoid, and it's located right in the center of the engine compartment at the back right next to the throttle body. The valve is held on with two 8-millimeter hex head bolts that need to be removed when replacing it. Next, unplug the electrical connector at the top of it, lift up on the tab and then pull out on the connector. Now You have to disconnect the vacuum line going in at the bottom of it. Take a flat blade screwdriver and push it in a little bit on one of the tabs on the side and then pull the hose off. There is an o-ring on the bottom of the valve they can stick a little, just wiggle it while pulling up to remove it.
FORD FUSION 2010 Fuel Pump Inertia Switch.
These switch's very rarely go bad . Check the voltage at both sides of the inertia switch . Don't BELIEVE anything without testing . Your Fusion has electronic returnless fuel system , a FPDM - fuel pump driver module control's the fuel pump .I'm looking at a fuel pump wiring diagram for your vehicle and it doesn't show a inertia switch anyway . Your best bet , have it towed to the dealer .
https://www.youtube.com/watch?v=Rwve6lXriO4&t=625s
Not finding what you are looking for?