Top 20 2001 Mitsubishi Montero Sport Questions & Answers

If engine sits front to back, right side is bank 2. If it sits transverse, rear bank is #2.

2001 Mitsubishi... | 277 views | 0 helpful votes

The hardest part of this repair is removing the two nuts. Soak them with penetrating oil first. If the nuts loosen stop and remove the vacuum line. Then remove the two nuts and pull off the EGR valve. A 90deg. mini pick and carb cleaner can be gently used to remove carbon buildup in both chambers. Before getting too carried away with cleaning. You should perform a vacuum test. Find out if the diaphragm is intact or leaking. Also see if the plunger moves freely when vacuum is applied. Sometimes the old gasket can be reused but don't count on it. They do break and if so both surfaces will need to be thoroughly scraped and cleaned. Let me know if there is anything else. Good luck.

Mitsubishi... | 19 views | 0 helpful votes

u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable-store and it;s actually really illustrative

Mitsubishi... | 117 views | 0 helpful votes

Perform a fluid level check with the vehicle running and in park .

Mitsubishi... | 35 views | 0 helpful votes

Radio units when disconnected from the battery supply lock as an anti theft feature.
New units are usually supplied with the code in the paperwork it came with. With a used unit you will need the serial number marked on the side or the back of the radio. You can use this to find the code on lots of specialist websites.
Try more than one as some will charge for the service and others don't.

Mitsubishi... | 28 views | 0 helpful votes

there is a main relay on the right kick panel

Mitsubishi... | 50 views | 0 helpful votes

There are 2 fuse boxes. One under hood and one under inside dash.

Mitsubishi... | 28 views | 0 helpful votes

you can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

Mitsubishi... | 116 views | 0 helpful votes

It has no dedicated fuse, what is the problem with the speed control?

Mitsubishi... | 67 views | 0 helpful votes

I take help from online websites that have this service like helping in repair some like reliable- store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Mitsubishi... | 157 views | 0 helpful votes

Find where the ground wire for that left taillight grounds to the body remove the screw and clean that ground, otherwise if the taillight assembly uses a printed circuit could be a break in the printing, replace the whole assembly if thats whats going on.

Mitsubishi... | 80 views | 0 helpful votes

Need to check your battery connections and clean them. Or your battery is no good

Mitsubishi... | 50 views | 0 helpful votes

IF the skid control light went on, then there's a trouble code stored in the computer. Get the code read is ALWAYS the first step before asking for help. Otherwise you just get wild guesses that are mostly wrong.

Mitsubishi... | 25 views | 0 helpful votes

take the pan off clean both surfaces the tranny and the pan put an 1/8th " bead around the pan making put the bolts in the holes let dry for 20 to 30 min then put it together evenly torque the pan down from side to side and im sure the autoparts knows the correct fluid and how much

Mitsubishi... | 44 views | 0 helpful votes

Are you sure this isn't the clutch release bearing making noise, I bet it is.

Mitsubishi... | 88 views | 0 helpful votes

A shorter time period could help also the brand name is in important, I ,ve found over the years that N.G.K. to be very good,also check the earth wire is clean and tight.

Mitsubishi... | 65 views | 0 helpful votes

First this may be difficult, but here are the basics. Go buy a set of plastic tools at Harbor Freight to remove the door trim panel. It will be a combination of screws and plastic pop-in plugs that you have to pry out and you need those plastic tools not to wreck the trim panel. Label and unplug any wires holding the trim panel on. Once the trim panel is off, you should be able to see the power window motor. You are now on your own as I would have to see it to figure out how to get off. Check to see if there is a You-Tube video for your particular car. Some are good. Some of these things are easy to get off. Some are monsters. I never took one off a Mitus.

Mitsubishi... | 34 views | 1 helpful votes

If the engine runs but the car does not move, there might be a problem with the transmission in the car. It mainly depends if the car is an automatic or a manual. Refer to your car dealership and they will run tests and give you a thorough answer.

Mitsubishi... | 38 views | 0 helpful votes

Tried to take neg off battery for 30 minutes? These vehicles have adaptive learning, (i have a mitsu galant), If that doesnt help you may have to go to dealer to have learning cleared.

Mitsubishi... | 75 views | 0 helpful votes

Not finding what you are looking for?
2001 Mitsubishi Montero Sport Logo

7 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Montero Sport Mitsubishi

  • Montero Sport Mitsubishi

Most Popular Question

side bank 2 2001 mitsubishi montero

  • Cars & Trucks