20 Most Recent
2014 Nissan Maxima Questions & Answers
1995 3.0 engine. Where is the crankshaft (position) sensor?
In the 1995 Nissan X-Trail with a 3.0-liter engine, the crankshaft position sensor is typically located on the engine block. However, it's important to note that the 1995 X-Trail model was not available with a 3.0-liter engine. It's possible that you may be referring to a different Nissan model or engine.
To provide you with accurate information, please specify the correct Nissan model and engine.
Power locks fell into door
Remove door panel by prying out at the bottom. Follow around door and remove the panel retainering tabs. Push up on panel to remove from top of door. Now snap the window lock button assembly back in place.
How to fix 00 maxima
00 maximas don't have swirl control valves that feature wasn't added until 01 unless by some wierd chance your max was made after July in 00 and is cal spec
Engine light is on so
CODE P1574 - ASCD VECHICLE SPEED SENSOR. POSSIBLE CAUSES, HARNESS OR CONNECTORS CAN COMMUNICATION LINE IS OPEN OR SHORTED. UNIFIED METER AND AC AMP. VDC TCS ABS CONTROL UNIT WITH VDC MODELS. ABS ACTUATOR AND ELECTRIC UNIT CONTROL UNIT WITHOUT VDC MODELS. FAULTY WHEEL SENSOR. TCM AT MODELS. ECM FAILED.
Where is the cruise control fuse located on a Maxima 2000 GLE
Refer to Owner's Manual for ASCD operating instructions. POWER SUPPLY AND GROUND NFEL0190S01 When ignition switch is in the ON or START position, power is supplied: + through 10A fuse [No. 30, located in the fuse block (J/B)]
to ASCD brake switch terminal 1 (LHD models) and + to combination meter terminals 47 and 50. + through 15A fuse [No. 20, located in the fuse block (J/B)] + to park/neutral position relay terminal 1 (A/T models), + through 10A fuse [No. 10, located in the fuse block (J/B)] + to ASCD control unit terminal 5, and + to ASCD brake switch terminal 1 (RHD models) Power is supplied at all times: + through 15A fuse [No. 2, located in the fuse block (J/B)] + to the stop lamp switch terminal 1, and + through 10A fuse [No. 57, located in the fuse block (J/B)] + to the horn relay terminal 2. When park/neutral position is in the P or N position (A/T models), ground is supplied: + to park/neutral position relay terminal 2 + through park/neutral position switch and body grounds F41 and F39. When ASCD main switch is depressed (ON), ground is supplied: + to ASCD control unit terminal 9 + from ASCD steering switch terminal 4 + to ASCD steering switch terminal 5 + through body grounds M9, M25 and M87 then ASCD control unit holds CRUISE condition.
Not finding what you are looking for?