20 Most Recent 2010 Dodge Challenger Questions & Answers

It goes between the PCM and the PCM connector, it is "sandwhiched in to the system.

You should not have jumped it from there, there are hook up points to jumper the car under the hood. You may have damaged the alternator or the computer that controls the output voltage. At this point you need a dealer to run some tests with a special scanner.

Your question is...? If any significant amount of water got into the intake while your car was running, the engine has very probably been destroyed. If, on the other hand, sufficient water did NOT get into the intake to destroy the motor, it's still possible that water got into any of the electrical connectors and/or the car's electronics, in which case the electronics may be toast or - in the best of all worlds - the car may be fine after all water has dissipated from inside whichever electrical connectors (this may take a very long time).

your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.

No, no cost. We volunteer as "experts." :)

I gather it is a V6 so looking at the engine left front is number 1 right front is number 2 and so on back and forth so this means right rear is number 6

Class A Cylinder Misfire, that will ruin your exhaust converter,possibly & eventually the motor Stop using it & get your codes & diagnose them

did you take the bulb assembly out, open the trunk,on either side behind the light there are two wing nuts, remove them and the assembly comes out, unplug the light and remove the bulbs, they will un clip from the back,two receptacle, id replace both bulbs, and keep the good one for a spare, put it back together takes about 30 minutes, Matt

there should be a fixture in the boot/trunk that holds the lights,that clips into a panel, find the clips that hold it in and release the lights fixture then you can change the bulb, clip fixture back in

The belt buckle sensor might be unplugged under the seat. Or the wiring or switch it self may be broken.

Remember it takes fuel, air , spark to make a engine run. Start checking fuel pressure then spark. Hope no one shoved any rags in the motor and bolted something over it.

Installing a battery is a quick job, should take no more than 10 minutes. The battery is located in the front of the car under the hood.