20 Most Recent 2011 Dodge Avenger - Page 7 Questions & Answers

bad timer switch or wiper switch

did you replace the turnsignal bulb?

does it shift ok and are you getting any check engine lites on the dash?

does it have a belt tensioner on it? Did you have to remove the belt when you replaced the alternator?

Whers the fuel pump? f it is in the fuel tank you have to either pull the tank or it has a axcess cover you remove and pull the fuel pump out from there.

remove the 4 bolts the seat 2 in the front 2 in the back also you need to undo the plug for the power seat switch as well as the single wire plug for the sensor for when you sit on the seat, you may have to remove the inner seat belt as well the bolt is under a plastic cover and it requires a torx socket hope this helps

Ebay part. It will list all vehicles the fender will fit. Kind of a "reverse" interchange book, but it works.

May be ignition module. What model year and engine size ?

Hope that is everything you are looking for

Computer can have a problem which will put it into the limp in mode. Have it diagnosed at a shop that specializes in electronic repairs or go to the dealer.

Man, I can say, it su(ks to be you..I can't fathom why they wouldn't put a key lock in the door. But here's what you have to do.( I don't know what Paula is talking about?) You have to remove the drivers seat to be able to remove the door panel. the panel HAS to come off to get access to the door latch. This is where the problem is. Most likely the latch has to be replaced. But you could have other parts in there that have to be replaced. Once you get the panel off, look inside the door(have a good bright flash light). Since the lock works it could be plastic pieces broken. You'll have to reach in and release the latch. there is a rod that goes from the outside handle down to the latch(the rod could be just hanging there). It is held in place by a plastic clip. Push down on the latch part to open the door. If that doesn't work, you have to go to the inside handle. It is a cable. Follow it back to the latch, grab the latch arm and pull it towards the front of the car. It should release the door. If it still won't release and open. Your going to have to cut/grind the latch out. Probably have to replace the door. Seriously bad set up.

You must have this mis-categorized. The Dodge Avenger was discontinued at the end of the 2000 model year, and was reintroduced in 2007. There WAS a 2003 Avenger concept car that was at some car shows, but no production models.

sounds like your blower motor has stopped working check for power going to the blower system if you have power the blower is probably bad the concern is the lack of a fuse blowing or a breaker not cycling you may have a harness problem sometimes a low grade short will heat up wires then melt them together causing a multisystem failure even though a fuse or breaker didn't blow check you harness

Check the light bulbs themselves. If those are still good, (don't touch the glass on the bulb), then check all your fuses. Chances are, the foglight fuse is linked in with something else.

THIS MIGHT HELP

what kind of vehicle? My own f150 wouldn't crank and it turned out to be the starter relay. $10.00 and 20 minutes to change. Does it go click when you turn the key? do the lights work?

check the dashboard dimmer control, either part of or next to the headlight switch, sometimes the contact on the rheostat goes bad or the contact at the connector plug

https://www.google.com/webhp?sourceid=chrome-instant&rlz=1C1GGGE_enUS385US385&ion=1&espv=2&ie=UTF-8#q=dodge%20avenger%20fuse%20box%20diagram%202008