20 Most Recent
2010 Chrysler Town and Country - Page 7 Questions & Answers
How do i raise and
You should find a small plastic tab at the base of the headrest. If the headrest is down, you will have to force your hand under it and feel for it - it is fitted on one of the rods that the headrest rides up and down on. Once you find it, push on it as you pull the headrest up.
2010 Chrysler T & C
A whine from under the hood could possibly be a power steering pump. It can whine even when it's full of fluid if the pump is bad. If you're car is a 2010, won't it be covered under the warranty?
~Brandon
Cant get headrests out
You have to find a small button located on top of the seat where the leg of headrest gets in. Press the button and pull the headrest at the same time.
Good luck.
How do i turn on
It was hiding from you in plain view (see picture below). I hope this helps and good luck.
Power outlet in rear 2001 town and country van is
It probably has it's own fuse. some times kids put things in the lighter sockets or stuff just falls in there. Pennies are real popular for causing that. Either that or a higher amp device was plugged in the socket and blew the fuse.
Chrysler Town and Country. How to get in with flat battery and open the hood?
Question edited for clarity.
Question moved to category.
There are two ways.
Get under the engine and attach a car battery charger red lead to the heavy red wire on the starter, connect the black wire of the charger to any clean bare metal part. In 15 minutes, you will be able to open the doors.
Or, call a locksmith out.
How SERVICE LIGHT RESET for
- Remember that light means it's time for a service on your vehicle. Oil change mainly. To reset the service indicator light follow these steps.
- Switch off the ignition.
- Now turn the ignition to "S" for steering lock.
- Next press and hold the "A" button.
- While holding the "A" button start the ignition and continue to hold the "A" button until the screen goes to ")" and the light goes off.
- Switch off the ignition and the resetting of the light is complete.
- Hope this helps and thank you for using FixYa.
Regards,
Tony
How to get limp mode off with code P1698 on 2000 Chrysler town and country.
You should NOT be driving this vehicle if it is in limp mode. You will need to pay a Good Auto-electrician to look at this problem.
All modern cars and trucks are fitted with electronic control units referred to as the PCM and the TCM. P1698 refers to these units not communicating properly with each other. So the vehicle goes into a safety set up until the problem it fixed, Limp Mode.
Not finding what you are looking for?