20 Most Recent 2010 Chrysler Town and Country Questions & Answers

Change back from what .......

2010 Chrysler... | Answered on Sep 27, 2019

This car is ten years old I didn't know the mileage. The codes mine something. there is something wrong.

2010 Chrysler... | Answered on Jun 16, 2019

Disconnect one battery lead and measure parasitic current draw with DVM set to 10amp range and test leads connected in series with disconnected battery cable and battery post. With ignition in the off position and vehicle doors closed. Remove fueses one at time to isolate circuit which is drawing current from battery.

2010 Chrysler... | Answered on May 19, 2019

You need to replace the rear latch assembly it sounds like the switch inside latch is going bad.

2010 Chrysler... | Answered on Apr 23, 2019

Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go the re and try

2010 Chrysler... | Answered on Mar 26, 2019

spray the latch down with starting fluid to remove grease then spray it with silicone to lubricate as grease will bid up lock lever worked for me

2010 Chrysler... | Answered on Dec 02, 2018

Check all fuses and then check the blower motor to make sure it is not at fault.

2010 Chrysler... | Answered on Dec 08, 2017

That is normal operation, as long as the door is open the door ajar switch senses that and keeps the interior light(s) on.

2010 Chrysler... | Answered on Sep 06, 2017

Blowers usually run on a 20 or 25 amp fuse..There are also resistors that could be bad if the fuse is not blown and the blower won't work on all speeds. I don't know exactly where the fuse is but the fuse box door usually has a diagram on the inside showing what fuses operate everything..The resistors could be located on the firewall in the engine compartment or somewhere on the heater housing..Check fuses first..

2010 Chrysler... | Answered on Mar 08, 2017

You don't need to replace them all. You have two types. J type is square with a clear cover. It looks like two shiny balls(solder joints) on wire. If the joints aren't shiny, replace them first. The others are M type. These are opaque, see threw. You'll have to pull them to see is the wire is broken. Best is if you say what is happening to the vehicle and codes are really helpful. Your fuse panel is a computer also. I have replace quite a few of them in Chrysler products.

2010 Chrysler... | Answered on Dec 22, 2016

Not finding what you are looking for?
2010 Chrysler Town and Country Logo

231 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Town and Country Chrysler

  • Town and Country Chrysler

Most Popular Question

2010 chrysler town country touring v6

  • Cars & Trucks