20 Most Recent 2011 Buick LaCrosse - Page 5 Questions & Answers

Battery Disconnect or Replacement Problems Your best bet , take it to the dealer .

You must remove the washer fluid tank, it is bolted from inside the wheel well I believe.

Please consult your owners manual or contact the dealer. If its not in the Owner's manual it is not an option.

Yes it is easy to fix.

Videos on youtube trouble shooting misfire's .

Please follow the link, the year is not important. http://workshop-manuals.com/buick/lacrosse/v6-3.6l/engine_cooling_and_exhaust/cooling_system/thermostat_housing_engine_cooling/component_information/service_and_repair

It could be under the right front passenger seat or center console (if it has one)

Are you sure you want to do that ? Are you guessing that's the problem ? Do you know what DTC'S - diagnostic trouble code's are ? DTC B2610 The body control module (BCM) applies a voltage reference through the instrument panel (I/P) dimming voltage reference circuit to the interior lamp switch. When the switch is placed to the desired position, the dimmed voltage setting is applied from the interior lamp switch through the I/P dimming return circuit to the BCM. The BCM applies the dimmed voltage to the I/P lamps supply voltage circuit. Do you know how to do electrical testing ? Reconnect the lamp switch assembly. Disconnect the body control module (BCM) connector C1. Using a DMM, measure the resistance between the I/P dimming voltage reference circuit and the I/P dimming control circuit. Vary the I/P dimming switch from full bright to full dim. Does the DMM, display change? Did you perform the Diagnostic System Check - Vehicle? Yes - Go to Step 2 No - Go to Diagnostic System Check - Vehicle 2 Verify that the interior backlighting does not dim. Does the interior backlighting operate normally? Yes - Go to Testing for Intermittent Conditions and Poor Connections No - Go to Step 3 3 Do the instrument panel (I/P) lamps dim? YES - Go to Step 13 No - Go to Step 4 4 Do the class 2 lamps dim? Yes - Go to Step 5 No - Go to Step 6 5 Test for a short to battery positive voltage in the I/P lamps supply voltage circuit. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? Yes - Go to Step 14 NO - Go to Step 13 6 Disconnect the lamp switch assembly. Does all the illumination of the backlight components turn OFF? Yes - Go to Step 8 No - Go to Step 7

You need a scanner to pull the trouble codes these cars have issues with the traction control/stability control systems.

Or a bad throttle body perhaps

Thermostat needs replacing. The wire spring inside the top hose that keeps the hose from collapsing has eroded away. You'll need a new hose too.

headlight switch...also some were on timer to shut off 30 sec after leaving vec. is so headlight module

so why do you want to know this ?

what engine 3.6 or 3.8