20 Most Recent
2012 Ford Taurus Questions & Answers
What is the torque for the inner tie rod to steering gear on a 2012 Ford Taurus?
you can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
Engine light is on then a wrench light comes on for awhile. When this happens the car slows down to a crawl.2012 ford tauras
The wrench symbol light is a warning light for the electronic throttle control system . Drive by wire ! The system uses electrical inputs from gas pedal sensors to the engine computer ,then by the voltage signal inputs the PCM - engine computer controls a electric motor to open throttle blade . This allows more air to enter the engine , the PCM can see that increase in air volume by the inputs from the mass air flow sensor . The PCM will add more fuel so you can go faster . Cool ! When the light comes on and the vehicle slows down , it's gone into limp mode . The PCM saw a voltage input it didn't like . There are two position senors in the gas pedal assembly and there are two throttle position sensors in the throttle body on the engine .
Drive by Wire training Check out a few of these training videos ! GM ,Ford , Toyota , doesn't matter all work the same .
Register SyncMyRide
No. I won't do it because you didn't say PLEASE.
Geez, why are people so rude? lol
No Low beam headlights
Do you know how to test automotive electrical circuits using a DMM - digital multi-meter ?
Principles of Operation
The headlamp switch is supplied power at all times from the smart junction box (SJB). When the headlamps switch is placed in the headlamps ON position, power is routed to the multifunction switch. Depending on the position of the multifunction switch, power is routed through one of two circuits to the SJB. If the multifunction switch is in the high beam position, power is routed through SJB fuse 12 (15A) and then on to the high beam headlamps. If the multifunction switch is in the low beam position, power is routed through SJB fuses 11 (10A) and 15 (10A) to the LH and RH headlamps, respectively. Power to the multifunction switch is available at all times for the flash-to-pass feature.
Is there B+ voltage at fuse's # 11 & 15 with headlamps on an the multifunction switch is in the low beam position ? If not check for B+ voltage at the multifunction switch . Free wiring diagrams here
http://www.bbbind.com/free-tsb Enter your vehicle info. year , make , model an engine . Under system click on lighting then under subsystem click headlamps . Click the search button then the blue link .
Basic Electricity for Service Techs Ohm law Current Flow Opens Shorts
Electric Testing Techniques You Need to Know
2004 Ford Taurus dashboard warning lights come on
I have same problem, 04 Tarus, Abs light, brake light, fuel cap light, oil pressure light, and one other, checked oil pressure with manual gauge and its good, has been doing this since it was new in 04, also radio has a mind of its own turns up and down on its own when warning lights are on.
2000 SE. How can I replace the belt tensioner?
remove belt make sure you have the routing diagram for the belt. Take old tensioner off install new one reinstall belt ,tensioner will need to have tension taken off with wrench take tension off install belt let the tensioner go easily and slowly.
Not finding what you are looking for?