Top 20 2013 Nissan Rogue Questions & Answers

Hello. Remove the headliner trim, overhead console(s) etc then gently pry the headliner down, at an angle. The seats will have to be removed for better working space. The overhead lamp console has 2-3 fasteners. Pry out the lens and remove the lamp. The fasteners are behind the lamp(s). Good luck and keep me informed; if you want to.

You should check out www.reliable-store.com they have info on repair, service, wiring diagram, electrical diagram, fuse diagram, troubleshooting, PCV, owner's/service/repair/parts manual, fault codes, error codes, etc everything on all vehicles. must check it out

the rear seat is probably bolted to the floor under the seat - thats if you are trying to remove it out of the car - my Q is what do you have to lift it up - usually seat cover wrap down and around and over the top. most covers have ties that are tied together for this - there is no reason that I see to pull the seat up- unless the bottom seat is right on the floor and that's why you are asking this - some rear seats have as they say hook into a bracket

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Nissan Rogue 2013 Factory Service Shop repair manual Year Specific FSM

I have a 09 kia spectra, The only time the horn will honk. is when I lock the doors with the remote. Unlocking just makes the lights flash! God-Bless! and hope this helps you out.

Here is what the service manual says. Looks like it is not a flasher relay but a function of the body control module. TURN SIGNAL AND HAZARD WARNING LAMP SYSTEMSystem Description OUTLINE Turn signal lamp and the hazard warning lamp is controlled by combination switch reading function and the flasher control function of BCM. TURN SIGNAL LAMP OPERATION - BCM detects the combination switch condition by the combination switch reading function. - BCM supplies voltage to the right (left) turn signal lamp circuit when the ignition switch is turned ON and the turn signal switch is in the right (left) position. BCM blinks the turn signal lamp. HAZARD WARNING LAMP OPERATION BCM supplies voltage to both turn signal lamp circuit when the hazard switch is turned ON. BCM blinks the hazard warning lamp. TURN SIGNAL INDICATOR LAMP AND TURN SIGNAL SOUND OPERATION - BCM transmits the turn indicator signal to the combination meter with CAN communication while the turn signal lamp and the hazard warning lamp are operating. - Combination meter outputs the turn signal sound with the integrated buzzer while blinking the turn signal indicator lamp according to the turn indicator signal. HIGH FLASHER OPERATION (FAIL-SAFE) - BCM detects the turn signal lamp circuit status by the terminal current value. - BCM increases the turn signal lamp blinking speed if the bulb or harness open is detected with the turn signal lamp operating. NOTE: The blinking speed is normal while operating the hazard warning lamp.

IF ITS A AUTO MAKE SURE IT IS IN PARK POS

These days, it is a function of the BCM.

What's the 2012 Nissan Rogue turn signal relay location?

https://www.vehiclehistory.com > questions > whats-the... 3 answers The 2012 Nissan Rogues turn signal relay, which is referred to as a flasher in some parts of the world, is housed firmly within the cars dashboard. https://forums.nicoclub.com/flasher-relay-location-t386148.html https://www.google.com/search?q=2016+Nissan+Rogue+SV.+Where+is+the+flasher+relay+unit

Manual https://owners.nissanusa.com/content/techpub/ManualsAndGuides/Rogue/2016/2016-Rogue-owner-manual.pdf In 15 years here, this is the only fuse box that doesn't show in search from sites like 'fuseboxinfo'.com https://www.google.com/search?q=2016+Nissan+Rogue.+fuse+box+diagram ..

Master Warning: An exclamation point inside a triangle lets you know there's a problem in the engine function. This could be as simple as a loose fuel cap, an open or improperly secured trunk or door, or other problem.

1. Place the ignition switch in the ON position. 2. Push and hold the sunroof switch toward 2 . Once the sunroof has reached the full tilt position, release the switch. Push and hold the switch toward the 2 position again. After a delay of four seconds, the sunroof will make a small movement and backup. 3. Release the switch. 4. Within 5 seconds of releasing the switch, push and continuously hold the switch toward 2 . The sunroof will move from the tilt position to the open position and back to the close position.

hmm sounds like the trans needs a bit of work on done to it as this isnt normal for any trans to hang in first gear like that it seems like as if its having issues shifting in a timely manner due to low oil or pressure plates sticking inside the trans

They aren't manual from outside, are they?

have battery checked at auto zone or most big stores, its free

This is a nice security feature, to stop people stealing it. Its easy to steal an unlocked car with the engine running.

2008 Nissan Pathfinder 4.0 not start when cold wether

Michael its a oil cooler it sounds like the gasket is blown just replace it no need to drain engine but u will get oil rfunning out put some thing under to catch oil

Your alternator isn't charging your battery so your car is draining the battery. Have auto zone test your alternator

Why not actually go to the dealer & into the service bay & see the problem for yourselfIf that is not allowed leave & try a local more friendlyrepair shopA cooler can fail yes