Top 20 2013 Hyundai Elantra - Page 2 Questions & Answers


Possible issue with the clutch pedal lock out switch. This switch will not let the engine start unless the clutch is full depressed.

Hyundai Elantra... | 34 views | 0 helpful votes


Not sure about the Elantra but if I think that might be the car that I had a problem with before that has a double tube in the tank filler spout it designed to let the gas tank burp and they will come loose and fall and bind and not let the gas flow properly

Hyundai Elantra... | 53 views | 3 helpful votes


Check for loose or dirty battery terminals and posts, could also be a faulty circuit breaker if fitted.

Hyundai Elantra... | 189 views | 0 helpful votes


Even perfect electronics have trouble making an engine run properly if the mechanical parts aren't similarly in good order and when an engine obviously isn't right but nothing obvious is wrong it is time to check the less obvious, in particular check for dribbling injector(s) and bad spray patterns and of course fuel pressures.

It is also worth carrying out a cylinder leakage test (compression test is inadequate) to ensure the intake valve seats aren't leaking.

Hyundai Elantra... | 36 views | 0 helpful votes


See if ur ableto shift it at the trany with ur hand into gear go to underhood or under car to the transmission disconnect the leankage should popoff with screw driver maybe hard but it just pops up have someone start car hold foot on brake with ebrake on and shift it one click should be reverse take ebrake off and see if it goes in reverse if it does its ur shift solinoid right there werelinkage clips on if dont its inside ur transmissoin

Hyundai Elantra... | 24 views | 0 helpful votes


There’s a website https://big-manuals.com that has top class repair solutions for all DIY Repairs.. They can fix any problem. Must visit..

Hyundai Elantra... | 24 views | 0 helpful votes


search online using code. it OBD 2 and standard code for vehicles

Hyundai Elantra... | 124 views | 0 helpful votes


Check the fuel presser ,by train few time you build presser in the fuel line and this will open the injectors to spry ,all the best.

Hyundai Elantra... | 38 views | 0 helpful votes


Wiring, schematic, electrical diagrams etc are basic contents of these online books they here on this website www.reliable-store.com Must check it out

Hyundai Elantra... | 69 views | 0 helpful votes


What can I say. You have bashed a delicate piece of electronic equipment, and probably broken it completely. You are going to have to take it to a repaired and get hem to look at it. If you had done this in the first place, it may have been a cheap repair, now that you have broken it, it is probably going to be more expensive. Try not to do this next time.

Hyundai Elantra... | 54 views | 0 helpful votes


Check condition of ambient sensor located in front of rad.
Also check for green corrosion from sensor connector to
next joint connection.

Hyundai Elantra... | 709 views | 0 helpful votes


Alarm circuitry usually memorises the battery voltage half a minute-ish after being set. If the sensed battery voltage falls too fast because the battery is (almost) faulty or in a low state of charge, the alarm brain will believe a door has been opened and switched on the interior light.
That is one scenario of several possibles...

Shaking the car is very unlikely to trigger a modern car alarm though opening a door should - because it doesn't it might indicate it isn't being armed (or fully armed), perhaps because it can't find a stable battery voltage to lock onto or perhaps it thinks there is a door, bonnet or boot open due to defective switching, the bonnet is most likely.

Hyundai Elantra... | 2,969 views | 0 helpful votes


Check the fuse for the sensor heater. Check the wiring harness. If you're getting battery voltage in the connector at the sensor, then the sensor heater is bad.

Hyundai Elantra... | 265 views | 0 helpful votes


may be something here to assist you.
<https://www.google.ca/search?q=99+hyundai+elantra+where+is+the+pcv+valve+located&rlz=1C1CHBD_enCA756CA756&tbm=isch&source=iu&ictx=1&fir=KCTcbsR5DIY9tM%253A%252CCYFP4mSMPjMd3M%252C_&usg=__9XbCR3Q6piOiRUSqqTpJLDvxP4w%3D&sa=X&ved=0ahUKEwjQ6vK00evaAhUk3IMKHejgDpUQ9QEIPjAE#imgrc=KCTcbsR5DIY9tM:>

Hyundai Elantra... | 26 views | 0 helpful votes


It should be on the left side of the engine block close to the firewall

Hyundai Elantra... | 99 views | 0 helpful votes


Best thing go to www.reliable-store.com they have got books on every vehicle and also how to service/repair it,
service/repair/owner's/maintenance manual with
parts info, fuse box, gear box, PCV, torque specs,coiling, wiring diagrams, electrical diagrams, fuse diagrams, error codes, etc everything

Worth it

Hyundai Elantra... | 39 views | 0 helpful votes


indicates that the insulation rubbers around the subframe bolts are failed and the subframe is hitting on the cabin floor or the cabin floor in taht area is rusted out

Hyundai Elantra... | 27 views | 0 helpful votes

Not finding what you are looking for?
2013 Hyundai Elantra Logo

28 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Elantra Hyundai

  • Elantra Hyundai

Most Popular Question

2013 hyundai elantra stereo

  • Cars & Trucks
Loading...