20 Most Recent 2013 Dodge Avenger - Page 8 Questions & Answers


need to go to dodge dealer with registration and vin number and they will make you a key20.00

Dodge Avenger... | Answered on Feb 06, 2013


Hi there have you tried the ignition coil as this sounds like the coil is getting hot and creating an open circuit thus no hi tension voltage to the spark plugs,once it has cooled done the car will start again until
it repeatedly gets hot and shuts down very common in pre coil pack vehicles,easy test try a spare coil and drive for same or more distant if not fault them coil is U/S

Dodge Avenger... | Answered on Feb 05, 2013


Check throttle control relays. Alo, look at throttle positioning sensor, replace as needed.

Dodge Avenger... | Answered on Jan 21, 2013


Before changing any parts, you need to see if there are any codes set in the computer. If you don't have a code reader, go down to Auto Zone and have them scan the car. If there are any codes stored,make sure you get the actual codes so you can post them here.

Dodge Avenger... | Answered on Jan 01, 2013


You are almost there. The problem is a faulty idle air control valve IAC. This is a ECU controlled electrical device that allows air to by pass the the closed throttle plate when the engine is at idle. When you disconnected a vacuum line you introduced air into the inlet manifold effectively doing what the IAC should be doing. The IAC is located with the the throttle body. Remove the air ducting from the air cleaner to the throttle. Clean the throttle body interior if dirty ( a cloth dampened with WD40 or carb choke cleaner works well). There is a passage in front of the throttle plate that leads to the IAC. Make sure this is clean. Disconnect the IAC and unbolt it from the throttle and take care not to damage the gasket as you can reuse it when you reassemble. Make sure everything is spotlessly cleaned. The valve is a motor driven pintle, again this should be thoroughly cleaned and should be checked that it is free to move. When the IAC and the air passageways on the throttle are looking like new reassemble everything, remembering to reuse the gasket. Reconnect the electrical plug and that should the job done. If the problem persists check that the IAC motor is working. If not it will need replacing.

Dodge Avenger... | Answered on Jan 01, 2013

Not finding what you are looking for?
2013 Dodge Avenger Logo

Popular Tags

31 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Mike

Level 3 Expert

4372 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Avenger Dodge

  • Avenger Dodge

Most Popular Question

find camshaft position sensor in dodge

  • Cars & Trucks
Loading...