2009 Volkswagen Routan - Answered Questions & Fixed issues

Use a standard Chrysler dipstick for the year and engine size. It will not seat because they removed the dipstick but you can check the level with it. They did this to get your money.

need to repair or replace the housing or ignition switch if broken with in housing

To remove it you must remove the head unit from the dash and then remove the chassis cover from the head unit and retrieve the CD

Sounds like transmission is not working. Good luck Mai

Duplicate question.

There is no dedicated fuse control fuse.

You should have the "Hot & Cold" lever which has a cable that opens and closes the water flow that allows heat to go to the rear heaters. Might of come off from lever, it's broken or frozen. If you are mechanically inclined, recommend you check this component first.

All involve brakeing system. I would take it to my dealer without delay, driving very carefully. These systems need to be working for your and your fellow drivers safety.

Replacing my fuel filter, Where is it located?

What is the firing order for a 2011 VW routan 3.6l standard six cyl order, 153 624

Possible shift control solenoid problem. Is the check engine light on? You may have to have the transmisson control module scanned for any codes to isolate this issue.

Did you check to see if the rubber blade did not glue itself to the window? It does happen.

Crest Lock INC.10015 Pulaski hwy Baltimore Md.4102567800 they will install it for the cos

After researching this it could be the BUS WIRING HARNESS problem and you are not the only person experiencing this. Check to see if there are any recalls on that vehicle. click on this link Home National Highway Traffic Safety Administration NHTSA and do a search for recalls, there is also a place on the website to enter your vin # and see if any of the recalls were done. right now I found four. but without knowing specifics I cannot say if your particular vehicle is affected. You can also submit a complaint with your problem while there

http://www.google.co.uk/url?sa=t&rct=j&q=&esrc=s&source=web&cd=4&cad=rja&uact=8&ved=0CDkQtwIwAw&url=http%3A%2F%2Fwww.youtube.com%2Fwatch%3Fv%3DNaSiuYaPdIU&ei=y87FVKXvPLKZ7Qapm4CYBA&usg=AFQjCNFp_MSQTg6GA_338lKjuEEQx1xUyA&bvm=bv.84349003,d.ZGU

Pressure test the system with appropriate tester,use mirrors for inspection,check your warranty status,recalls etc....

This is an old post...but it happened to me today. Electrical works, but car will not start. I disconnected the battery cables (both) and touched the positive cable to teh ground cable hopefully trying to discharge the codes. Left it alone for a few minutes and reconnected the cables. The car started immediately?? Yes...I will now keep a 10mm wrench in the car for next time.

Does your Routan have the multi zone control. The back temperature can be controlled separately from the front. Look at the console on the roof between the front and middle row seats. There is a mixture control there that will control the temperature for the back.

look it up on autozone.com

Scan this machine-The OBDII system has this information.....Autozone will lend you a scanner and have a code discription guide if you are handy with such things(all can be done with patience and for free)Replacing parts blindly is not a way to go with VW......