2008 Nissan Quest - Answered Questions & Fixed issues

Did you turn the auto open button off ? It is one of the buttons on the roof console by the phone icon. Does the tail gate open?

see link below is for a 2007 i believe it is the same procedure

Do you have a set of "Flex/Wobble head" extensions? That may work. See picture, look at where the socket attaches.

Check fuse and power to rear gate , motor is inside the tail gate.

It is hidden behind the side panels. You have to remove the rear seats. The panels mostly just pop off. But remove the access panels to find hidden screws. When pull the panel/s, if they don't want to come off with force, mostly there is a screw close by.

Google--- got to use that alot--- every day type: obd & your codes Nissan OBD P1726

should be a button in the glovebox somewhere..

Best 2 deal straight 2 Nissan general Manager & demand it 2 be rectified ASAP threaten them with court appearance _ see U in Court!!! Fix it now or I will C U in Court!!!!! That should get the ball rolling 4 U!!!!! Good luck!!!

faulty sensor on hatch .

If this is a new vehicle, you should have an owners manual with it; it would have that information in detail.

if its the ecu moduel you have removed the car might think it been stolen and the anty theft devise has kicked in thats why it wont start may have to take it in and put on m/c to reset it hope this helps ivan

top off the coolant level

replace the beeper that makes the sound when you are in reverse.the light will also go out after you replace thet beeper.

ok whats problem?? check out there web site for answers

If it starts then it is not a loose connection, the deck is likely the problem.

i need to replace a broken back light lens on a 2000 quest

Check and see if your cooling fans are working. At least one should come on at all times when the a/c is turned on.

most sites wont let you down load for free maby a page or two// what you need to do is go down to auto zone and order a hayanes repair manuel they cover every thing you can find in a owners
manuel plus a lot more the best part is it will cost you less than a down load that might have a
virus in it


hope this helps you
good luck
bob

We are assuming that your check engine light mean or advise one P0303 code; this means that the the car's computer has detected that one of the engine's cylinders is not firing properly. In this case it's cylinder #3.

A code P0303 may mean that one or more of the following has happened:
* Faulty spark plug or wire
* Faulty coil (pack)
* Faulty oxygen sensor(s)
* Faulty fuel injector
* Burned exhaust valve
* Faulty catalytic converter(s)
* Running out of fuel
* Poor compression
* Defective computer

Possible Solutions:
* If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.
* If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Test it and send us news about your advance.

What is the problem? Send us details.