20 Most Recent 2008 Mazda Tribute - Page 4 Questions & Answers

That's telling us that the abs is passing the self check when you turn on the key. When th e light comes on after you start moving it usually means that a sensor is not sending a single or a signal is messed up. A scan tool will tell you wich wheel to focus on. It is fairly common for the exciter rings on the front drive axles to break and cause this code. It wouldn't hurt to inspect these for crackps or misalignment. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com! I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Ihave the same problem,checked all ith fuses??Dose any one have the answer??

I have a same problem. need help

pqtrahan, I don't know where the fuse is located, but, my advice to you is to test all the fuses in the passenger and engine compartment and replace any that are bad. You may find what you are looking for. Good luck with this.

fuse blown comes to mind 1st but the door plunger in the door jam may only be sticking. look towards the drivers door while setting in the seat, do you see a plunger type button that when pushed by hand,does it go in and out with help? or does it stick? also check interior light and accessories fuse.

A code P0113 may mean that one or more of the following has happened:

• Internally failed IAT sensor
• Faulty connection at IAT sensor
• Open in IAT ground circuit or signal circuit
• Short to voltage in IAT signal circuit or reference circuit
• IAT harness and/or wiring routed too close to high-voltage wiring (e.g. alternator, spark plug cables, etc.)
• Faulty PCM (less likely but not impossible)

it means maintenance is due

SOUNDS LIKE A BAD BATTERY, TRY JUMP STARTING IT, IF IT STARTS. REPLACE BATTERY OR TAKE TO SHOP. MOST SHOPS WILL TEST BATTERYS FOR FREE.

You have a relay going bad or, and this is more likely, a cell going bad on the battery. Replace the battery and your problem should be resolved.

try web resourceful.com for complete auto manuals online

No it should not spew. You should be ab le to slowly allow eqalazation as you loosen the fittings. You may get a little leakage as this is normal when changing the fuel filter onn any vihicle