20 Most Recent
2009 GMC Yukon XL - Page 8 Questions & Answers
Replace left front wheel bearing on 2002 yukon 4x4 abs
Remove the axle nut. Put a punch in the fins of the rotor to keep the hub from spinning.
Remove the caliper and the rotor.
Unplu the abs harness.
Remove the three bolts that hold the hub to the knuckle.
Remove the hub/bearing from the knuckle.
Reverse to install. Make sure you torque the three bolts that hold the bearing to the knuckle and the axle nut to the correct torques spec. Failure to do so will cause premature bearing failure.
Also use a good quality bearing. SKF is a good brand.
Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com! I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
Air or heat only blows
The reason it only blows on high is the blower resister bad..As far as the a/c when it blows hot is the compressor still lock in..If not it could be a bad connection to the compresser or a bad a/c clutch
My 03 Yukon xl Instrement
Hi
Sounds as though u have experience the GM usual cluster failure.Check
for bad connections in the fuse box. Use a test light to verify voltage at all
of the fuse holders.Also check for bad solder point on the board behind the
display.Seems you need to replace the entire instrument cluster.
Please get back to us if you have further query else please accept
this particular suggestion.
Thanks for contacting fixya.com
2001 yukon xl, rear axle
Needs rear axle seals which requires removal of the rear axles. Shafts must be inspected to make sure the surface the seal rides on does not have wear.
Not finding what you are looking for?