20 Most Recent 2008 Chevrolet Aveo - Page 5 Questions & Answers

You might want to look at all the hot surfaces under the hood. it sounds like something made of plastic is touching something hot.

The vehicle may be over fueling or not getting enough fuel at idle . Could be caused by a sensor in the engine reading improperly, spark plugs with excessive gap or a vacum leak. Chances are this vehicle has a check engine light on that would give you a better indication of what sysem is being affected causing the problem.

Trade it in on a male model not a female,LOL:

what has to be done about a p2188 on a chevy aveo, could it be the gas?

you will need to unscrew the center console

CHECK FOR YOUR BRAKE LIGHT SWITCH IT IS LOCATED BEHIND THE BRAKE PEDAL UNDER THE DASH. FOR A TEST DISCONNECT IT AND SEE.

Hi there:Check this on 2008 Chevrolet Aveo Car Stereo Wiring Diagram...

Car Radio Battery Constant 12v+ Wire: OrangeCar Radio Accessory Switched 12v+ Wire: YellowCar Radio Ground Wire: BlackCar Radio Illumination Wire: Brown/WhiteCar Stereo Dimmer Wire: Light Green/RedCar Stereo Antenna Trigger Wire: N/ACar Stereo Amp Trigger Wire: N/ACar Stereo Amplifier Location: N/ACar Audio Front Speakers Size: N/ACar Audio Front Speakers Location: N/ALeft Front Speaker Positive Wire (+): VioletLeft Front Speaker Negative Wire (-): Light GreenRight Front Speaker Positive Wire (+): Light BlueRight Front Speaker Negative Wire (-): BrownCar Audio Rear Speakers Size: N/ACar Audio Rear Speakers Location: N/ALeft Rear Speaker Positive Wire (+): Dark GreenLeft Rear Speaker Negative Wire (-): GrayRight Rear Speaker Positive Wire (+): Dark BlueRight Rear Speaker Negative Wire (-): White

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.

disconnect negative battery cable. Then remove rubber boot on altenator. Remove nut and cable attached. Unplug and remove wire harness also attached to altenator. Loosen and remove both bolts holding on altenator.Remove altenator. Reverse process to reinstall. Pry on belt tensioner with pry bar and socket to loosen belt and place on altenator pulley after it is installed.Last reattach battery cable and start vehicle.