2008 BMW 3 Series - Page 3 - Answered Questions & Fixed issues

0helpful
1answer

BMW RADIO

This should help follow the link instructions.

http://www.e90post.com/forums/showthread.php?t=9390
2/12/2010 11:44:33 PM • 2008 BMW 3... • Answered on Feb 12, 2010 • 262 views
0helpful
1answer

I have a bmw320 the bonnet release handle wont

Did you try with 2 people. one guy pushes down on the hood and then pulls up after the other pulls and holds the release.
Grease the latch every so often to prevent this.
10/14/2013 6:13:58 PM • 2008 BMW 3... • Answered on Oct 14, 2013 • 352 views
0helpful
1answer

I wish to remove radio toi9nstall Nokia CK-15W

Ok what do you need to know....your question did not state anything but what you want to do. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
2/2/2010 3:25:40 PM • 2008 BMW 3... • Answered on Feb 02, 2010 • 78 views
0helpful
1answer

328i won't start. Turns over but doesn't fire.

Sounds like your fuel pump has stopped working get it checked out.
12/27/2009 11:29:33 PM • 2008 BMW 3... • Answered on Dec 27, 2009 • 1,286 views
0helpful
1answer

Need to know the exact size of rims for a 2008

2008 BMW 323i 4 door sedan - factory wheel rim size

Rim size (standard factory spec):
16 inch by 7 inches wide.
Front and rear are the same size.

(It is possible to fit 17 or 18 inch rims to the car if you wish together with an appropriate lower profile tyre ).

(please note that different models in the 2008 3 series BMW have different size rims. For example, the 328 and higher level models runs larger rim sizes).

Hope this helps. Cheers
12/8/2009 11:29:16 AM • 2008 BMW 3... • Answered on Dec 08, 2009 • 387 views
0helpful
1answer

The back of my seat is stuck..it doesnt go back

the cable must of snaped that controls the back, or a gear, youll have to remove the seat put it no a work table then you may have to remove the seat covering to the back a little so that you can see the linkages, now power up the motor that operates the back and watch what isnt moving, then youll see your problem, good luck hope this helps
11/26/2009 6:05:55 PM • 2008 BMW 3... • Answered on Nov 26, 2009 • 107 views
0helpful
1answer

Rain sensing wipers on 2005 320i BMW do not work correctly

but windex on the wind-sheild and rain-x especially where the rear-view mirror sits. dust can give a false signal to the wipers.
11/7/2009 9:18:21 AM • 2008 BMW 3... • Answered on Nov 07, 2009 • 337 views
0helpful
1answer

How do I reset oil service indicator on N43

the dealer should have done it unless you serviced it yourself. you may have to take it in to have it reset.
11/7/2009 2:30:18 AM • 2008 BMW 3... • Answered on Nov 07, 2009 • 374 views
0helpful
1answer

Theres a red light i my dashboard always on i

Have you checked the spare? otherwise it is likely to be a faulty sensor in a wheel, a decent tire shop is likely to be cheaper than BMW (unless warrenty is still good)
10/28/2009 12:46:28 AM • 2008 BMW 3... • Answered on Oct 28, 2009 • 141 views
0helpful
1answer

How do I change the Air Filter on a BMW 320d ?

very easy open house remove old air filter, vacuum out housing and replace with new filter....should take about 5 minutes...
10/7/2009 4:54:21 AM • 2008 BMW 3... • Answered on Oct 07, 2009 • 547 views
0helpful
1answer

Drivers seat electric 4 way switch How do I get

The switch assembly is inserted from the bottom-up. You will have to remove the door panel to access and service the switches.
10/5/2009 11:24:19 PM • 2008 BMW 3... • Answered on Oct 05, 2009 • 57 views
0helpful
2answers

Where can find the Cigarette Lighter fuse

Cigarette lighter and electric plug do not work in 2007 Caliber after use of Magellan GPS - put in a new fuse - still doesn't work. Would anyone have a suggestion as to how to repair this problem? Thank you
10/22/2009 6:37:52 PM • 2008 BMW 3... • Answered on Oct 22, 2009 • 1,594 views
0helpful
2answers

How do I unblock BMW 320i windscreen washer?

Hi,

Put a cupful of something like cillit Bang in the reservoir, fill the system up with a hose pipe and leave the hose running. Operate the washers until the water runs clear. Turn the hose off and empty the reservoir. Refill with the correct concentration of screen wash, job done for about 10p!

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
9/18/2009 11:12:09 AM • 2008 BMW 3... • Answered on Sep 18, 2009 • 1,448 views
0helpful
1answer

I have a 2001 bmw 320d se. The rear heated does not work.

There should be a guide under the cover of the fuse box.
8/30/2009 3:07:36 PM • 2008 BMW 3... • Answered on Aug 30, 2009 • 496 views
0helpful
1answer

One of my daylight running side lights has gone in my 2008 bmw 3

it either screws into place or you should be able access it from under the hood or from underneath the vehicle
8/25/2009 11:15:34 AM • 2008 BMW 3... • Answered on Aug 25, 2009 • 219 views
0helpful
2answers

BMW will not start

In Rear RH Side Of Luggage Compartment. lift up floor covering
7/20/2009 2:54:35 AM • 2008 BMW 3... • Answered on Jul 20, 2009 • 203 views
0helpful
1answer

Dashboard dials not working

If your temp and fuel gauges are playing up then check ALL the fuses under the bonnet. My brother in law's 1998 381Ti compact started playing up with the fuel and temp gauges swinging about like they had a mind of their own. Turned out to by the rear brake light fuze....
7/17/2009 3:53:45 PM • 2008 BMW 3... • Answered on Jul 17, 2009 • 1,261 views
0helpful
1answer

BMW 320D / 2007 - Handbrake binds - only when car faces downhill

possible cause for handbrake binding is either air in brake system (re bleed system) or brake caliper stiking
6/21/2009 5:41:19 PM • 2008 BMW 3... • Answered on Jun 21, 2009 • 440 views
0helpful
1answer

Bmw 320cd 2006 model handbrake

Hi, if you lift the hand brake gaitor that covers the lever you will see what looks like a spring with a washer and a clip passing through the washer. Release the handbrake lever to release tension on the cable then unclip the clip from the washer, then you will need to remove one wheel bolt to gain access to the adjuster rod. Raise the rear wheels so that they rotate freely and look through the hole left by the removed wheel bolt untill you see a toothed wheel. Using a long screwdrive you will need to adjust this wheel untill the road wheel does not move then wind the toothed wheel backwards (approx 6 teeth) do this for both wheels, once done fully release the hand brake lever and the clip should relocate in the washer, this should then have adjusted the hand brake
2/11/2009 11:34:36 PM • 2008 BMW 3... • Answered on Feb 11, 2009 • 326 views
0helpful
1answer

Bmw 3 series e90 fuse box symbols explained

On this website you find fuse box diagram and description for BMW 3 series (E90) BMW 3 Series E90 E91 E92 E93 2005 2010 fuse box diagram Auto Genius
11/11/2018 9:18:00 AM • BMW 3 Series... • Answered on Nov 11, 2018 • 3,319 views
Not finding what you are looking for?
2008 BMW 3 Series Logo

145 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top BMW Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...