Honda Prelude - Recent Questions, Troubleshooting & Support - Page 8
How to change the third brake light on a 2001 honda prelude
The lens either has a small tab that you release it with or there are screws. It this is on the interior then the finishing cover just snaps on. Use something not metallic if you need to assist in gently prying at it. A screw driver may crack your glass.
Why crankshaft pulley come loose ?
check the bolt holes and bolts to inspect for damaged threads and repair or replace as needed. if this is good you may need to add Loctite to the threads of the bolts. use blue Loctite as this will allow removal later on if you need to remove the bolts.
My 1998 honda prelude has no signal to icm
Test or check the crank position sensor. Look for the 5 volt reference signal (your prelude may have a higher reference voltage- I don't know), check that the ground wire is good, then see if you get a signal from the signal wire. See if you can back probe the signal wire with the engine cranking. If the sensor is at fault, the ecu cannot determine spark timing.
Look at a wiring diagram to see if the camshaft position sensor is also part of spark timing.
Rough idle after warm up
It can be a number of things, check for vacuum leaks at the manifold, fuel filter,pcv valve, iac valv
Non interference engine
Honda engines are interference engines which means that valve damage will occur if the belt has broken or the correct procedure is not followed during belt replacement.
Not finding what you are looking for?