Dodge Ram 1500 - Recent Questions, Troubleshooting & Support

I took my 2004 Dodge Ram 1500 5.7L Hemi to a mechanic that works from a garage at his home, recommended by a friend of mine. He removed and cleaned the throttle body and sensor(s?), then reinstalled them, and then disconnected both battery cables and held them together for 2 minutes so that the engine controller could reboot with the factory default settings, then reconnected them. I had bought a can of throttle body cleaner on my way over to his house for about $3.00. He charged me $40.00 for the job. This was done mid-February, about 10 weeks and 2500 miles ago. So far, the problem Has Not happened again, the truck has been running great!

2004 Dodge Ram... | Answered 16 hours ago

Here is the link to view the serpentine belt diagram for 4.7 Dodge Ram 1500:

2004 Dodge Ram... | Answered on Jun 02, 2020

A diagram should already be available inside the hood on the radiator support of the fan covering. If not, follow this link: Basically, if the pulleys are grooved, the belt ribs ride on it, and if the pulley is smooth, the backside rides on it.

2004 Dodge Ram... | Answered on May 18, 2020

A 2005 ram 1500 5.7 hemi
Why the engine turns off when the neg. Cable is detached from the batterie?
I already change alternator for a new one.

Dodge Ram 1500... | Answered on May 10, 2020

Hi Javier, Im AL the owner of Big As Auto Repair

Javier, ABS Module is located under the hood. It mounts to the side of the hydraulic brake system. Hope this helps and please visit my auto-repair website and check out the satisfied customers and give me a shout while your there.

2006 Dodge Ram... | Answered on Mar 12, 2020

code p0443=It's whining about the control circuit for the purge valve. Make sure you are getting power to the valve, and you see 12 volts on the control side as well.

code p0445 might be just a gas cap problem.

Dodge Ram 1500... | Answered on Feb 16, 2020

It's a map/tps sensor correlation code, essentially it means the map sensor reading isn't what's expected with the tps reading and vice versa! It sounds like your tps sensor is probably bad or the circuit to one of those 2 sensors.

Hope helps (remember rated this).

2004 Dodge Ram... | Answered on Jan 08, 2020

I think you should try this website big-manuals . It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page

Dodge Ram 1500... | Answered on Dec 16, 2019

My personal suggestion
would be to go for these repair catalogs. I know this website that i used to buy them from, and they sold online it was very good manual. Go ahead, I bet.

2001 Dodge Ram... | Answered on Dec 03, 2019

have it checked for vacuum leaks

Dodge Ram 1500... | Answered on Dec 03, 2019

Since the tires are a different size than the computer is programmed for that could be the problem right there. U cant fool the computer.

2004 Dodge Ram... | Answered on Nov 23, 2019

Causes A P0501 DTC trouble code may be caused by one or more of the following:
  • The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
  • There is a broken/frayed wire leading to the vehicle speed sensor
  • The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
Possible Solutions The simplest thing to do is to reset the code and see if it comes back.
Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly.
If the wiring and connectors are OK, then check the voltage at the speed sensor. Again, the exact procedure wil depend on your make and model of vehicle.
If everything looks OK, replace the sensor.
Further Reading Vehicle Speed Sensor (VSS) Description and Operati

2004 Dodge Ram... | Answered on Nov 21, 2019

check with code scanner for fault code/or bring to garage to scan for fault code

2001 Dodge Ram... | Answered on Nov 19, 2019

Watch the video. Ignition Pick Up Coil Sensor Replacement How to Dodge Dakota

This Video applies to all models that use the 5.2L V8

Dodge Ram 1500... | Answered on Nov 08, 2019

Get an OBD reader and see what it says.

Dodge Ram 1500... | Answered on Nov 06, 2019

Fualty blend door or a bad blend door
actuator when when you turn it to the cold side will it cut the heat from the side the is working

Dodge Ram 1500... | Answered on Oct 31, 2019

Press "NAV" to go to the main navigation menu.

Scroll down and select "System Settings"

Scroll down and select "Clock Setting"

Make sure "Show GPS Clock" is selected with a red check in the box.

I had to switch "Daylight Savings" from "ON" to "OFF" in order to bring the time back an hour. I assume that I'll just have to switch it back to "ON" in the Spring in order to move the time forward and hour.

2006 Dodge Ram... | Answered on Oct 17, 2019

"No Bus" means the communication bus is down (the network connecting electrical parts and computers). This is usually a wiring/connector problem. Check for loose connectors, wiring, etc.

2000 Dodge Ram... | Answered on Oct 04, 2019

Most likely problem are the horn pads in the steering wheel. Check to see how sensitive they are when the horn is not engaged. It it honks with very little pressure, then you found the problem.

Dodge Ram 1500... | Answered on Oct 03, 2019

Not finding what you are looking for?
Cars & Trucks Logo

-5,613 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dodge Cars & Trucks

  • Forum

View Most Popular

  • Dodge Cars & Trucks