How to replace brake pads on a 2004 Yamaha 350 Bruin ATV

Question edited for clarity.
Question moved from motorcycles to ATV model category.

Turning over has nothing to do with the carburetor! Your battery is flat. It will need charging.

If the carb is leaking, it is because the float is set wrong or the float valve needle isn't seating properly.

Engines only need three things to run.

A supply of clean fresh fuel (not sitting a year)
A Spark at the right time.
Compression.

You say you cleaned the carb **in** carb cleaner, as opposed to *with* carb cleaner. Did you strip it down, check the float for holes, clean the jets and needles?

Question edited for clarity. Add maker.
Question moved to Yamaha Bruin category.

Likely to be a fault with the ignition switch Karen. There is help in the link.

https://www.google.com/search?q=2004+Bruin+350+won%27t+switch+off

..

there should be a screw located on the bottom of the float bowl. but on some quads it might not be easy to reach without long skinny flat head screwdriver. my suggestion is to take off the carb and give it a good cleaning. water can cause deposits and lead to clogs

stamped on the side of lower frame rail below left footrest.

look for a vin number usually by neck our engine cradle--some have numbers on manufacturers tag

not familiar with that model but I think most yamahas are on the frame under the foot pegs

all yammies I know have them under the left foot peg.

Going by this it would be 110 foot lbs...this was VERY hard to find...and I found it here...http://www.maultechatv.com/techguides/Service%20Manuals/YAMAHA/ATV-SxS%20Service%20Data%201995-2009.pdf

Hope this helps took me an hour to find this...

Close to the battery on thr red wire in a plastic cylindrical fuse holder.

TTTERE