Question about ATVs

1 Answer

I have a 2004 artic cat 400. wont start by start button. i have no lights either

Posted by Annie W on

Ad

1 Answer

Priscilla McDaniel

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 213 Answers

Sounds like a short or a discounted wire.

Posted on Jul 12, 2019

Ad

4 Related Answers

Stan Ford

  • 2951 Answers

SOURCE: Have an artic cat 400 4x2, not sure of the year. I get it started through the reserve primer then i switch over to regular tank it idles fine for a short bit then it revs high and quits. Any ideas

It is not getting fuel from the reserve tank for some reason. check for a blockage some where , may be a fuel filter.

Posted on May 28, 2015

Ad
claudeinmo

Claude Kayser

  • 9098 Answers

SOURCE: Pulled the plug wire off the right cylinder and it killed the engine

Electrical Diagnosis for Arctic Cats - YouTube

? 9:58
https://www.youtube.com/watch?v=iwwl4LPyOCY
Dec 29, 2009 - Uploaded by BlaineDP
When in the "OFF" position the switch will ground the ignition wireto the chassis effectively "grounding out" the ignition systemkilling the spark. ... becomes disconnected or if a wire gets cut then the switch will no longer turn off the engine. ... Testing a stator in a snowmobile Arctic cat - Duration: 3:25.

CAT AS NO SPARK!! - American Snowmobiler Magazine ...

cs.amsnow.com > ... > Forums > Manufacturers > Arctic Cat snowmobiles
If the connection to any switch; key, kill, tether, throttle safety switch, etc.. is ... Some older model Arctic Cats have the ground up closer to the handle bars on ... Here is a general rule of thumb for putting spark plug wires on which cylinder for Cats: ... Pulledthe ECU cover off and found some corrosion; I had a 580 that did not ...

Posted on Jan 16, 2016

Nicola Conroy

  • 1428 Answers

SOURCE: 2008 artic cat 400atv cranks but wont start. no spark at plug

Compression test maybe.

Posted on Mar 18, 2017

5keepers541

Steve P

  • 3712 Answers

SOURCE: show how to time a artic cat 2006 250 artic cat

The timing is set electronically..(if the engine is assembled correctly)

Posted on Jul 03, 2017

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 artic cat 400 4x4 changed the magneto and stator it will pull start but will not start if I use the button. I have jumped the relay I tried jumping it from a car Still nothing it just clicks.


a really bad battery thats shorted out can even cause jumping not to work. could be time for a starter rebuild also. junk inside shorting the armatures.

Apr 12, 2017 | ATVs

1 Answer

I keep losing spark and my 400 artic cat will not start. I have checked the ignition coil, magnets, and the cdi. What should I check next?


Sometimes when bad parts heat up they fail. I have seen this with the cdi. Be very aggressive when checking your connections. Do you lose spark after it has been run for a while or at certain temps?

Apr 02, 2017 | Arctic Cat 2004 400 DVX

2 Answers

The starter engages and starts the motor fine when the motor is cold. however if you ride and try to restart the starter just spins and you can only start using the kick stater.


"ATV" service and repair manuals - CRXSi.Com

www.crxsi.com/reference/manuals/atv/
.. arctic cat 400 4x4 engine · 04 arctic cat 4x4 400 4 wheeler manual trans startergears ... 2000 2x4 red atv artic cat repair manual · 2000 300 arctic 4 wheeler instructions .... 2007 arctic cat 90 c c four wheeler wiring diagrams · 2007 arctic cat 90four .... Atv Arctic Cat 2010 - Arctic Cat Dvx 300 And 300 Utility Service Manual ...

Aug 12, 2015 | Arctic Cat 2007 90 DVX 2x4

1 Answer

Continuous high idle and idle screw no help


Does your artic cat have a carb cable if so it will have an adjustment or a clamp on the cable where it attaches to the linkage..check make sure it is set to low idle..and your idle screw is adjusted to low idke..meaning cable adjusted to lowest possible position when the throttle is released..then make your final adjustment using you idle screw..good luck

Oct 22, 2014 | ATVs

1 Answer

Gap settings on Spark Plug for 2007 Artic Cat 400 4x4


From what I understand it is stamped on the left side of the cylinder head, behind a hose.

If this does not help, contact artic cat dealer and speak to a service rep.
Hope this helps!

Sep 20, 2014 | ATVs

1 Answer

Artic cat 400 i started it let it run for 10 minutes and then it died and will not start now is not getting any fire to the spark plug


guessing you changed the spark plug? .. you can fry the coil from heat...I used to wrap coils in rags when I tested them on a coil tester to try to make them break down from the heat quicker. It worked too.

Mar 29, 2014 | Arctic Cat 2004 400 DVX

Not finding what you are looking for?
ATVs Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

23504 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

ray gallant

Level 3 Expert

70857 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...