Question about Polaris ATV
Test the compression using a compression tester.
My guess a valve is stuck closed.
A compression test will show this.
Posted on Mar 31, 2019
I hope you got this problem fixed, just happened to my predator, it was indeed the voltage regulator. I picked up a service manual that includes part numbers and installation procedures from www.promanuals.net for 15 bucks.
Posted on Sep 26, 2009
SOURCE: 1994 Chevy K1500 engine cranks
The troubleshooting charts for your ignition system are copyrighted and I cannot post them here. You can have access to them by subscribing to alldatadiy.com fo a small fee.
The MOST LIKELY cause of your problem is a failed distributor module. (inside the distributor) The symptoms you described can also be caused by many other things like loose or corroded connectors or even a failed Powertrain Control Module (PCM)
Please also review this article:
What Else Could Be Wrong?
Posted on Jul 18, 2011
SOURCE: 1998 Ford Explorer, 4.0 SOHC No
You are at thhe right trail what controls spark is coil pack crank sensor sparkplugs and plug wire but the most important is power . I mean 12 volt connections and ground This includes checking fuses you need a simple volt meter doesnt have to expensive or fancy just to pick up 12 volts let start with fuses in the engine juction box (there not mark to what it belongs to) make sure none are open. especially fuse 19 and 24 , next go to the crank sensor make sure the tabs are snuggly on now to the coil pack there is a red and light green wire this comes from ignition and feeds 12 volts at the coil pack measure that voltage is it 12 volts if not correct it this is from ignition switch ( you can make a tool that feed 12 volt with a wire and a fuse in series and attatch it to battery and the primary wire this is known as hot wire) next go to the ECM wiggle the wires see if that get a connection going if not go back to the ICM here are the wire you are to measure the tan light green, this is from ECM and it is pulsed it measure 5vlts to 0 volts switched then measure the tan orange the same thing 5 volts to zero,then tan white again 5vlts to zero. any one of these 5 to zero fails you fix is the ecm
Posted on Aug 21, 2011
Tips for a great answer:
Sep 26, 2017 | ATVs
Feb 28, 2017 | Polaris ATV
Jul 06, 2014 | ATVs
Aug 12, 2017 | Polaris ATV
Mar 05, 2012 | RTO 125cc Full Size Adult Quad ATV
Dec 31, 2017 | Polaris ATV
Dec 05, 2017 | Polaris ATV
Jun 05, 2019 | Polaris ATV
216 people viewed this question
Usually answered in minutes!