Question about Polaris ATVs

Open Question

Adjust deck belt tension

Put new belt on my 2004 trailboss driven clutch only has one shim in it and that's the minimum my deflection is over 3 inches motor mounts look good am I missing something or can I adjust trans or center of clutches is a hair under 10 belt slips on primary a lot cleaned surfaces real good does anyone have advice to fix my deflection.

Posted by Anonymous on


1 Related Answer



  • 114 Answers

SOURCE: Clutch slipping on new bike

This is a new bike right? So it under warranty, so it would be best to bring it back to the dealer.

ATV Snow Plows

Posted on Mar 27, 2013


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have 2003 polaris trailboss 330 and it keeps jumping into neutral. What can be the issue

Try re-adjusting the shift linkage. Also, make sure it has the correct amount of oil in the tranny.

Sep 26, 2016 | ATVs

1 Answer

1999 Sportsman 335 4x4. Why doesn't it seem "right"?

Make sure it is the recommended size. Can you adjust the tension? Try some belt dressing, it's a spray that makes belts grab better. Good luck!

Feb 29, 2016 | Polaris ATV

1 Answer

How to adiust drive belt on Kawasaki Prairie 360

Once you get the black cover off you'll need to remove the driven clutch and take out a couple shims. Be careful not to lose any parts.
Most dealers have a set rate for that and it may be of your best interest to take it to a dealer. It's not that it's complicated it's just that there is a proper measurement for the correct tension. If the tension isn't correct you may find your bike stalling on you when you come to an abrupt stop.

Sep 09, 2014 | kawasaki 2009 Prairie 360 4x4

2 Answers

I just put new clutches in 85 honda 250 four trax y are thay steeel sliping

Sometimes you need to adjust your clutch cable. as the disks wear out you have to tighten it to get it to disengage. if the cable is adjusted too tight then it will slip because it is not taking all the pressure off the disks so they can fully grab. That is where i would start

Jul 29, 2014 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

Yamaha 2005 raptor 80- clutch not engaging

ever put a clutch in? 100% sure you have the discs in right? It could very well be that it is adjusted too tight and won't release the clutch. Usually happens when you go from a bad bad over adjusted clutch to a nice new one.

Aug 03, 2013 | Yamaha 2005 Raptor 80

1 Answer

How to replace a drive belt on my 2001 polaris trailboss

go to youtube and look for polaris belt changing vids. its pretty easy and they're all similar.

Aug 08, 2012 | RTO 125cc Full Size Adult 4 Wheelers ATV...

1 Answer

1987 polaris trailboss piston

Sure - it is worth fixing when a new one is 2300

Mar 31, 2010 | RTO 200cc Full Size Four Wheeler ATV

Not finding what you are looking for?
ATVs Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts

john h

Level 3 Expert

23424 Answers


Level 3 Expert

85239 Answers


Level 3 Expert

858 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides