Question about Polaris ATV

1 Answer

Polaris 325 magnum

The quad will still go but only when its in 4x4 and only the front tires turn the back tires don't move and when the quad is in 2 wheel drive it dosnt go at all its like its still in nutral if you know what it could be please let me know it would be greatly appreciated thanks contact me at [email protected] thanks for your time

Posted by Anonymous on


1 Answer

Michael Gasperik

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 3 Answers

It sounds like it could possibly be the ring gear in the rear differential. (Where the drive shaft enters the diff.) If the ring gear gets stripped the drive shaft will turn but it's not transferring that power to the rear axle. Lift the rear end off the ground and spin the rear wheel by hand. Listen for a clicking sound at the rear differential. If it is clicking then I would bet the ring gear is stripped.

Posted on Nov 17, 2017


5 Related Answers


  • 1 Answer

SOURCE: 2001 Polaris sportsman 500 magnum 4x4, speedo dont work

I'm not sure but it might be the sensor on the right front wheel disk

Posted on Sep 05, 2009



  • 13 Answers


an ohm test on the hub coil wires will identify whether or not it is a bad magnet. test between the brown and grey wires and thisd should be aruond 27 ohms. then test brown to ground this should be open. you can also test 12volt power to the coil between thos two wires

Posted on Feb 18, 2010


  • 13 Answers

SOURCE: my 02 325 polaris magnum wont go in four wheel

NOT Trans. polaris 325 have electro magnetic "clutches" in front hubs. NO POWER TO THEM ... NO 4WHEEL DRIVE

Posted on Mar 27, 2010


  • 1 Answer

SOURCE: oil change for polaris 325

Drain plug is on the bottom of the crankcase. No need to pull skid plate. Combo fill hole and dipstick is on the lower left hand side of the engine
Don't forget to do the filter at hte same time.

Posted on Sep 05, 2010

donald simpson

  • 1 Answer

SOURCE: I have a 325 polaris

I have a magnum 330 that the taillight stays on when quad is running and it shocks my handsevery so often

Posted on Oct 17, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why is my front driver side tire binding in 2 wheel drive

Probably dirt or grit got in to your CV joint check cv joint for tear or small rip

Feb 01, 2016 | Polaris 2014 RZR 4 900 EPS Orange Madness...

2 Answers

Polaris scrambler 400 won't shift out of 4x4. Any ideas why ?

On a website where another guy had this problem, the previous owner told the new owner that he shifted it into 4x4 while in the mud and it is now stuck in AWD. According to Blueline15: "previous owner did a very bad thing. for anyone who doesnt know, remember this example. although you can flip the 4x4 switch while moving, if your back tires are spinning while in 2wd, you can not go into 4x4 or you will cause this problem. just remember this, the flip on the 4x4 the front wheels need to match the rear in wheel speed. so either be moving and not stuck, or come to a complete stop.

what happened is you have rollers in a plastic cage in the front end. when he hit the 4x4 button with the rears spinning, the torque going to the front gearbox while everything was at a stand still that it broke the roller cage.
You're looking at a few hundred dollars at a dealer, depending on how bad."

I hope this helps.

Apr 26, 2015 | ATVs

1 Answer

Atv Manuals

the tow is out on it take a tape measure and go from tire to tire read what it say at the front and then go too the back of the tire and on the same tread location like in the front read the back on it say u have 16.5 inch on front and maybe 16.25 on back u want both these numbers the same so the wheels are fighting each other

Oct 24, 2013 | ATVs

1 Answer

Diff wont lock into 4x4

What's the year make and model of the quad?

Aug 29, 2017 | ATVs

1 Answer

I have a 2010 kawaski mule 610 4 wheel drive. The front drive shaft on the driver side is loose and the boot is torn. The shat just freely moves where it goes into the tire. It is like a part is missing...

Hey Dennis, there is no way to tell what part number(s) you need.. this is not a complicated repair, but does take some knowledge.. if you are not very good, mechanic wise, I would find a qualified professional to help with has to be RIGHT,, or it will break again..

Aug 24, 2017 | kawasaki 2005 Mule 3010 4x4

Not finding what you are looking for?
Polaris ATV Logo

Related Topics:

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts

john h

Level 3 Expert

23438 Answers


Level 3 Expert

85239 Answers

Tom Chichester

Level 3 Expert

58556 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides