Yamaha 2004 Warrior Base Logo

Related Topics:

A
Anonymous Posted on Aug 28, 2012

Why wont my 1990 warrior start, but can be push started, and will start after wormed up

My 1990 yamaha warrior 350 will crank over but not start. I can push start it just fine, after its warmed up it will start on its own, just not when its cold, any thoughts?

1 Answer

Robert McDermott

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

  • Expert 72 Answers
  • Posted on Jan 05, 2019
 Robert McDermott
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Joined: Aug 10, 2010
Answers
72
Questions
10
Helped
47361
Points
130

Clogged choke jet or passage for sure.

5 Related Answers

Anonymous

  • 40 Answers
  • Posted on Nov 25, 2008

SOURCE: Wont start when weather is cold.

Tune up... its flooding when its cold due to the plugs being worn out...

Ad

Anonymous

  • 42 Answers
  • Posted on Dec 30, 2008

SOURCE: 1990 chevrolet 1500 pickup starts hard when cold

Most likely the coolant temperature sensor for the vehicle computer. Secondly, could be the tps sensor "throttle position sensor" not registering correctly or perhaps lots of other things but most likely the coolant temp sensor.
Dale

Anonymous

  • 10 Answers
  • Posted on Mar 28, 2009

SOURCE: hard to start when cold. It tries but just wont

PLUGS, WIRES, AND BATTERY TERMINALS CORRODED. CLEAN TERMINALS FIRST IT'S FREE. :)

Anonymous

  • 147 Answers
  • Posted on Mar 29, 2009

SOURCE: 2001 chevy silverado won't start when warm

Possible weak spark from ignition coil or low fuel pressure due to weak pump. Try spraying carb clean into intake throttle body when problem is present. If vehicle will start and run with a little spray then fuel pump is failing.

Anonymous

  • 54 Answers
  • Posted on May 13, 2009

SOURCE: 96 Chev Silverado having to crank 3 - 4 times before start

Well the only thing i can think of is when your fuel is below half a tank the pressure relief valve and a rubber hose between the pump and the fuel line is exposed. Its possible your fuel is leaking back into the gas tank as it sits overnight, ect. You may want to perform a fuel pressure check when the the gas is at 1/4 tank and been sitting for awhile, pressure should hit 55 seconds after key is turned to run position.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I`m not getting power to my starter switch or my headlight switch. I have to jumpstart with A screwdriver at the solonoid. What is my problem. My atv is A 1995 yamaha wolverine 350

Sounds like a fuse. Yamaha uses a Negative start button. So start button shoul always be hot. When pressed it grounds circuit (closes) sending voltage thru solenoid. You should have power at solenoid on one of the small wires.
0helpful
1answer

YAMAHA WARRIOR 350 WIRING 1987

Hello, Get a FACTORY service manual and FOLLOW it to the LETTER and DO IT RIGHT!
Sep 09, 2018 • ATVs
0helpful
1answer

2001 yamaha 350 warrior that will start and idle but when you give it the gas it stalls.i've taken the carb off and cleaned it changed the plug. removed the wire from the emergency break lever. and it...

If you have good spark then it's most likely a fuel issue, anything off of idle is dealing with the main jet and metering needle, clean jet and check needle for excessive wear.
Oct 20, 2013 • Yamaha ATVs
0helpful
1answer

Yamaha yfm 350 warrior wont keep idle

Replace the idle jet (don't clean) with a new one from a Yamaha OEM only $5.00 & make sure the idle mixture adjustment on the bottom of the carb. is set 3 1/2 turns out from seated in (a brass screw ---Don't over tighten & break off the needle tip). Also , be sure the choke is all the way off or it won't idle either.
0helpful
1answer

1992 Yamaha Warrior 350 sound when letting of throttle!??

Check spark plug, that sounds like it's running little too lean.
0helpful
1answer

I have a 1997 yamaha warrior 350 with crack in the crank case that leaks oil... Would a high heat silicone fix it?

NO--- If you clean the case spotless of oil, 5 minute two part Epoxy will seal it. Let it set over night.
0helpful
2answers

My spark plug has no spark for my yamaha warrior 350. How would i fix this problem?

1. replace the spark plug with a new one...
2. check all your on/ff - kill switch(s)
3. If it still will not spark, you will probably need to find a pro with a service manual to start checking electrical system values...
0helpful
1answer

Hi i have a 1998 yamaha warrior, loosing spark

Go on ebay and buy a new CDI computer those bikes are notorious for computer failure.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

Not finding what you are looking for?

190 views

Ask a Question

Usually answered in minutes!

Top Yamaha ATVs Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

john h

Level 3 Expert

29494 Answers

Are you a Yamaha ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...