1
Steve Alakel posted an answer for this Peugeot Cars & Trucks:
"If the auto parts store has a listing for your vehicle with no A/C then you should be able..."
Steve AlakelSteve Alakel posted an answer for this Hyundai Cars & Trucks:
"The wiring between the ignition switch and starter motor needs to be restored to factory..."
Steve AlakelSteve Alakel posted an answer for this Cars & Trucks:
"Sounds like a bad t-stat. Is the heater output low?"
Steve Alakel
Steve Alakel posted an answer for this Saws:
"Check the receptacle for power. Also double check the voltage on the saw's nameplate. If..."
Steve Alakel
Steve Alakel posted an answer for this HEWLETT PACKARD - LASER JETS HP LaserJet Enterprise 600 M601n Printer:
"Open all of the access doors and close them making sure they are tightly secured. If that..."
Steve Alakel
Steve Alakel posted an answer for this 2000 Ford Expedition:
"Sounds like a cold start problem from the description. You should check the coolant sensor..."
Steve Alakel
Steve Alakel posted an answer for this 2005 Toyota Tacoma:
"Depending on where the noise is coming from you may want to start with checking motor and..."
Steve Alakel
Steve Alakel posted an answer for this 2001 Oldsmobile Alero:
"There is an o-ring that seals it just like the distributors use. Go to the GM dealer and..."
Steve AlakelSteve Alakel posted an answer for this 2000 Ford Expedition:
"There are many things that can cause this. It could be a stretched or jumped timing chain,..."
Steve AlakelSteve Alakel posted an answer for this 2001 Oldsmobile Alero:
"More than likely the ignition module is not firing the coil for cyl's 1 and 4."
Steve Alakel
Steve Alakel posted an answer for this 1999 Suzuki Esteem:
"Did you check the fuse for the stop lights?"
Steve AlakelSteve Alakel posted an answer for this 2000 Ford Expedition:
"2 hoses are for the A/C evaporator core. These are heavier hoses with fittings on them...."
Steve AlakelSteve Alakel posted an answer for this 2005 Toyota Tacoma:
"On OBDII vehicles there's 2 ways to reset the MIL. A scan tool can clear the codes, but..."
Steve AlakelSteve Alakel posted an answer for this Nissan Cars & Trucks:
"Your computer system is OBDII. You need a scan tool to pull codes from the PCM. I believe..."
Steve AlakelSteve Alakel posted an answer for this 2001 Oldsmobile Alero:
"Start by checking the brake lights. If the fuse is blown, the switch won't be powered up..."
Steve AlakelSteve Alakel posted an answer for this Cars & Trucks:
"Start by checking the Maxi Fuses. These are located in the main fuse panel. They are large..."
Steve AlakelSteve Alakel posted an answer for this Nissan Cars & Trucks:
"You should start by doing a back pressure test to diagnose a clogged catalytic converter."
Steve Alakel
Steve Alakel posted an answer for this 1993 Pontiac Trans Sport:
"You may want to do a fuel pressure test to start. The pump could be defective. The fuel..."
Steve Alakel
Steve Alakel posted an answer for this Water Heaters:
"The F10 error code on a Munchkin Boiler is flame sense. Sometimes removing the flame..."
Steve Alakel
Steve Alakel posted an answer for this 2007 Pontiac Solstice Convertible:
"You can remove the tire from the vehicle, make sure it is properly inflated, and spray..."
Steve AlakelSteve Alakel posted an answer for this 2007 Pontiac Solstice Convertible:
"i have a pontiac solstice 2007. right front tire has gone flat 3 times in the last 5..."
Steve Alakel
Steve Alakel posted a question about Kitchen Appliances - Others:
"Hello, I have a Harman P68 Pellet stove. The 250v 6 amp glass fuse keeps blowing. With the..."
Steve Alakel
Cars & Trucks 17 answers
Saws 1 answer
Office Equipment &... 1 answer
Water Heaters 1 answer
