Steve Todd posted an answer for this 2005 Harley Davidson XL 1200 C Sportster Custom:
"21/32""
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Replace the seal if leaking from the out put shaft, replace the gasket if leaking from the..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"There is a groove in the ignition switch housing, the groove runs 90 degrees to the..."
Steve Todd posted an answer for this Procom Heating & Cooling:
"Unscrew the black button where the valve is, after unscrewing you need to pull the button..."
Steve Todd posted an answer for this 2010 Harley Davidson XR1200:
"Loosen axel bolt, turn adjusters equal amounts until you have 1/4-3/8 inch deflection at..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Could be an intake leak. Spray connections (not electrical connections) between..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Dont run your bike. Drain the primary/transmission fluid and remove the primary cover. If..."
Steve Todd posted an answer for this 2010 Harley Davidson XR1200:
"In the 2013 sportster parts manual it fits ALL models and it comes with PN 10177 strap"
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Throttle cables got crushed or kinked by tie downs or throttle grip housing crushed. If..."
Steve Todd posted an answer for this 2005 Harley Davidson FXDCI Dyna Super Glide Custom:
"Cycle the engine run switch on the right handlebar. If that doesn't cure the problem take..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Check for crushed wires in the handlebars, is the clutch lever loose to move up and down,..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"You have to pull the outer primary, clutch, primary chain, and foreward drive sprocket, ..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"They do that when the mileage lines up with service intervals. It will go away on its own,..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Pinched/crushed wires in handlebars. The dimples not aligned with wires or levers moved..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Don't make it more difficult than it is. Align the wide groove and narrow groove so the..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Seeping like a connection at the quick disconnect is loose on one of the fittings? Or..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"My 1200c has the long spacer on the right (belt) side, short spacer on the left (brake..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Over filled with with transmission oil or "O" ring in cover is out of position. If it was..."
Steve Todd posted an answer for this Harley Davidson Motorcycles:
"Change the battery in the fob"