matthew walsh posted an answer for this Jl Audio Car Audio & Video:
"In your world, what does best results mean to you. how are the hifonics mounted? open..."
matthew walsh posted an answer for this Kenwood Car Audio & Video:
"Use the factory reset button to get out of standby mode. Locate a small hole on the lower..."
matthew walsh posted an answer for this JVC Car Audio & Video:
"keep all the levels flat. YOu'll get the best natural reproduction out of that setup for..."
matthew walsh posted an answer for this Car Audio & Video:
"The probable issue is your remote control. open and inspect it."
matthew walsh posted an answer for this Car Audio & Video:
"A quick trick on the faceplate connectors is to use the eraser of a lead pencil to clean..."
matthew walsh posted an answer for this Car Audio & Video:
"is the unit new? do you know how your FM antenna is wired. are you trying to pickup signal..."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"red is hot, black is ground."
matthew walsh posted an answer for this Rockford Fosgate Punch P5002 Car Audio Amplifier:
"input or output stages?"
matthew walsh posted an answer for this Rockford Fosgate Punch® 450.2 Car Audio Amplifier:
"12 gauge wire ought to work"
matthew walsh posted an answer for this Rockford Fosgate 100a2 Car Audio Amplifier:
"yes, it is repairable."
matthew walsh posted an answer for this Rockford Fosgate 800.2 Car Audio Amplifier:
"its all relative. keep the reds on the same side and the whites on the other."
matthew walsh posted an answer for this Rockford Fosgate 800.2 Car Audio Amplifier:
"not recommended ."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"open amp and resolder jacks back on the board"
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"will bet dollars to donuts the remote is a permanent hot. Check your wiring"
matthew walsh posted an answer for this Rockford Fosgate Punch 500a2 Car Audio Amplifier:
"yes, if you add a 1 ohm resistor to the negative terminal of speaker."
matthew walsh posted an answer for this Rockford Fosgate Punch 801S Car Audio Amplifier:
"what are the numbers on the cap."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"Are you interested in the filtering stage or the amplification stage"
matthew walsh posted an answer for this Rockford Fosgate Punch 200M Car Audio Amplifier:
"this is a full-range amp suited best for full range speakers,however it can still be used..."
matthew walsh posted an answer for this Rockford Fosgate 100a2 Car Audio Amplifier:
"repair it, or get a new one."
matthew walsh posted an answer for this Rockford Fosgate T1500-1BDCP 1500 Watt Class-bd Constant Power Amplifier Car Audio Amp:
"you have an internal short inside the amp"
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"how to install or where to install?"
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"add a 3 ohm resistor in series at the negative post of the speaker."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"amp is clearly overheating. you are over-driving the amp. you can, cool the amp better,..."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"where do you live"
matthew walsh posted an answer for this Rockford Fosgate Punch P400-4 - Amplifier - 4-channel:
"whats the issue"
matthew walsh posted an answer for this Rockford Fosgate Punch 150S Car Audio Amplifier:
"yes, they will work fine. best speaker? how much are you willing to spend"
matthew walsh posted an answer for this Rockford Fosgate T800-4AD 800 Watt Class-AD Full-Range 4-Channel Amplifier:
"Its been running hot."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"turn down the gain until you can go full volume without distortion. crossover frequency is..."
matthew walsh posted an answer for this Rockford Fosgate Car Audio & Video:
"what kind of noise"
matthew walsh posted an answer for this Concept Car Audio & Video:
"75 watts on 2 channels at 4 ohms."
matthew walsh posted an answer for this Soundstream Car Audio & Video:
"yes, it could be your amplification stages."