Press enter to search.
james curran posted an answer for this Ford Cars & Trucks:
"usual suspect is corrosion, i use Dielectric grease on all my plugs on my vehicle to keep..."
james curran posted an answer for this Dodge Cars & Trucks:
"u have a short in harness somewhere, try removing light bulb 1 at a time to see which wire..."
james curran posted an answer for this Chevrolet Cars & Trucks:
"u will need piece of brass pip and brass T to put in the spot where the temp sender is"
james curran posted an answer for this Chrysler Cars & Trucks:
"should have a access panel on inner fender well"
james curran posted an answer for this Cars & Trucks:
"fuel pressures usually run between 45 to 60 psi if suspect fuel pressure check the..."
james curran posted an answer for this Nissan Cars & Trucks:
"u have corroded wires, most likely on the ground side, check the fuel pump relay on the..."
james curran posted an answer for this GMC Cars & Trucks:
"there should be a panel on the inside side of the tailgate with screws, remove panel to..."
"most gm vehicles purge valve on those models are either on the square canister located on..."
"water pump is driven by timing belt under the timing cover"
"1st make sure oil is not coming from above like converter seal, output shaft seal, 2nd..."
james curran posted an answer for this Hyundai Cars & Trucks:
"u still have air in it, re-bleed but this time stop on it hard then close bleeder.as far..."
"if u are talking about the Mass Air Flow sensor, it is usually located on the tube from..."
"pull the abs fuse located in the motor compartment fuse block"
james curran posted an answer for this Volvo Cars & Trucks:
"your not in limp mode , you have a leaking fuel line, it causing low fuel pressure to the..."
"sound like1st shifting rod fork rod has a problem or syncros is worn out, its internal..."
"replace the clutch probably has a broken spring on the pressure plate or the clutch worn..."
"replace the radio it blew the internal amplifier"
james curran posted an answer for this 2002 Ford Mustang:
"you will need to check your ground connection on the body and motor for rust or corrosion"
james curran posted an answer for this Polaris ATV:
"you nee to locate the battery wire on the starter then with a test light or meter put the..."
"you need to get a radiator pressure tester (can use loner tool program at either autozone..."
james curran posted an answer for this ATVs:
"the plastic belt cover is out of position may be cracked under cover remove it and look..."
"sounds like you have a hole in piston check compression with a compression gauge, should..."
"change the drive belt"
"go to scribd.com and you can look at the service manual to diagnose the proceedure to..."
"check the shift rod from the shift box going to the back to the transmission for being..."
"it will be two things, 1st float level in carb adjusted wrong, or the rev limiter is bad"
"go to scribd.com and it will show you the service manual and what the production numbers ..."
"if seal too close for heat the you will have to you a real good drill bit cobalt grade and..."
"check to see if there;s power to the hub coils"
"you can either use RTV silicon or JB weld for a permanent fix"
"you will have to have a nulti meter and unplug the sensor and che the ohms on the sensor..."
Load more activity...
2,972 people helped
View all achievements