BRAAAAAAAAAP!!!! Find what you love and pursue it!
Gary posted an answer for this 2006 Suzuki Boulevard C50:
"timing off valves too tight too lean TPS bad chipped valve, bad valve seat, cracked..."
Gary posted an answer for this 2001 KTM EXC 300:
"if you need you bike jetted for 7000, take it to a shop and have it jetted. If you dont..."
Gary posted an answer for this 2005 KTM EXC 300:
"carb problems, improper jetting, to much oil in mix, filthy air filter"
Gary posted an answer for this KTM Motorcycles:
"bad center case seal, or main crank seal right side."
Gary posted an answer for this 2005 KTM 250 SX:
"the SX forks really should be taken to a suspension tech to get the inner chamber properly..."
Gary posted an answer for this 2005 KTM 250 SX:
"water pump seal"
Gary posted an answer for this 2000 KTM SX 125:
"kill switch short - unplug it! that is all that is left on the system, if it does not..."
Gary posted an answer for this 2008 KTM 250 SX-F:
"could be as simple as water in the fuel. kick starter issue: need to remove side cover..."
Gary posted an answer for this KTM Motorcycles:
"might loose a little top end, but should work great for trail!"
Gary posted an answer for this KTM Motorcycles:
"your throttle cable is improperly routed and is being pulled on!"
Gary posted an answer for this 2009 KTM 1190 RC8:
"blown head gasket"
Gary posted an answer for this Can-Am Care 2010 DS 90:
".004 intake .005 exhaust"
Gary posted an answer for this Yamaha 2007 Grizzly 700 FI Auto 4x4 Exporing Edition:
"the belt housing is filled with water. open the drain valve on bottom of housing, drain..."
Gary posted an answer for this Polaris 2012 Ranger RZR XP 900:
"code 85 is the gas pedal sensor (been a very common problem), unplug it, tap it, plug back..."
Gary posted an answer for this kawasaki 2007 Prairie 360 4x4 Camo:
"Carburetor was improperly rebuilt, or timing is off on engine."
Gary posted an answer for this KTM Motorcycles:
"no it wont work! pipe diameter is different"
Gary posted an answer for this KTM Motorcycles:
"if you smell coolant in the exhaust then the head gasket is most likely blown! That will..."
Gary posted an answer for this John Deere 2008 Gator XUV 4x4 620i:
"YOU DONT! Factory specs are need to test and set it! First off what is the problem you..."
Gary posted an answer for this 2003 Yamaha YZF-R1:
"11 - Cylinder Identification Sensor 14 - Intake Air Pressure Sensor (Pipe System) 15 -..."
Gary posted an answer for this Motorcycles:
"Radiator cap is bad. The reverse valve on the cap is stuck or damaged. It is not able to..."
Gary posted an answer for this Motorcycles:
"how about you give year make and model with a bit more info on the request."
Gary posted an answer for this 2009 Harley Davidson XL 883C Sportster 883 Custom:
"back off the center cable adjustment, or back off the idle screw on the carburetor. If you..."
Gary posted an answer for this Motorcycles:
"2004 engine if the tenth digit on the vin# is a 4 then the frame is also an 04"
Gary posted an answer for this 1987 Honda VT 1100 C Shadow:
"if the plug is white you are running lean. plug should be tan to medium brown. lean will..."