Tim Carter posted a question about Cars & Trucks:
"Replaced starter relay also"
Tim Carter posted a question about Scag SFZ52-26BS Freedom Z Zero Turn Rider:
"Have a scag zero turn with Kawasaki 23hp engine. Put new starter in and when switched to..."
Tim Carter posted an answer for this Locks & Locksmithing:
"local locksmith should be able to order for you"
Tim Carter posted an answer for this Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher:
"check your piston and nut assembly has to have air tight seal to drain properly should be..."
Tim Carter posted an answer for this Kwikset Locks & Locksmithing:
"take the screw out take a drill bit smaller than the set screw and drill divot into shank..."
Tim Carter posted an answer for this Locks & Locksmithing:
"should be able to take to a locksmith they should be able to call manufacturer and get..."
Tim Carter posted an answer for this Master Lock Locks & Locksmithing:
"either cut lock off or start at 0000 and progress on to 9999 and you will find combo"
Tim Carter posted an answer for this EZSet Locks & Locksmithing:
"lost keys to what type of lock?"
Tim Carter posted an answer for this Locks & Locksmithing:
"it sounds like the door or lock is out of adjustment with the door jamb, with door open..."
Tim Carter posted an answer for this Kwikset Locks & Locksmithing:
"spray a little bit of oil where you insert the key turn it a couple of time to make sure..."
Tim Carter posted an answer for this 1989 Pontiac Sunbird:
"if you take the title with your drivers liscense to a pontiac dealer & they can cut you a..."
Tim Carter posted an answer for this 1999 Mercury Cougar:
"try spraying oil inside cylinder run key in and out rapidly and then try and turn..."
Tim Carter posted an answer for this 1998 Buick Skylark:
"have they checked the key and the V.A.T.S. ignition?"
Tim Carter posted an answer for this 1997 Nissan Pickup:
"you would have to remove the ignition if you want to know how i will tell you but it would..."
Tim Carter posted an answer for this Mercury Cars & Trucks:
"check fuse if it is good check to make sure power is going to light switch if you have..."
Tim Carter posted an answer for this 1990 Toyota Pickup:
"try and start truck and once started let key come back a little bit and let me know if it..."
Tim Carter posted an answer for this Deadbolt RF Remote , Satin Nickel:
"the carbine deadbolt is mich like the lori bolt if you want to remove the deadbolt open..."
Tim Carter posted an answer for this 1999 Cadillac DeVille:
"It is possible you would have to disconect the ignition cylinder at the bottom of the..."
Tim Carter posted an answer for this 1992 Nissan Pickup:
"take a strong piece of round metal a metal hanger might work straighten it out about six..."
Tim Carter posted an answer for this 1992 Nissan Pickup:
"if you can locate a freon called freeze 12 it will mix with r-12 with now problems and you..."
Tim Carter posted an answer for this 1995 Buick LeSabre:
"bad fuel pump, or fuel fuse/relay check fuse or relay first"
Tim Carter posted an answer for this 1991 Cadillac Seville:
"more info needed. Did you replace the ignition cylinder? Key?"
Tim Carter posted an answer for this 2004 Ford F350:
"Check your fuel pump pressure, fuel pump may be going out"
Tim Carter posted an answer for this 1998 Toyota Avalon:
"key is worn down go to a locksmith and have a key cut by code"
Tim Carter posted an answer for this XO Vision X120AUD MP3 Player:
"I have the same computer and setup as you do itunes are for putting music onto ipods you..."
Tim Carter posted an answer for this 2001 Chevrolet Silverado 2500HD:
"They sell a tool at the parts store to remove the lines, or you can do what i did just..."
Tim Carter posted an answer for this Toyota Cars & Trucks:
"Call your local locksmith and have them come out and check your key and the ignition..."
Tim Carter posted an answer for this Dremel Variable - Speed Multipro Rotary Tool 395:
"if it idleing down and still turning loosen the chain a bit and oil the clutch"
Tim Carter posted an answer for this Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin:
"take off air cleaner and spray carb with choke and carb cleaner if that doesn't help try..."