Yamaha RS Viking Professional - Recent Questions, Troubleshooting & Support

Your information is on the ATV Forum

Throttle cable: remove the 3 screws on the right side of the carb, take off the cover, there is small rubber gasket (red) Don't lose it. you'll see the cable attached inside. move the mechanism forward like you're opening the throttle to get enough slack to unhook the cable.

Choke: on the other side of the carb, the choke cable screws in with a plastic nut (10 mm i think) unscrew with your hand, if its tight use pliers or wrench..its easy to unscrew it.

throttle choke cable removal Yamaha Grizzly ATV Forum

Yamaha Vehicle... | Answered on Sep 12, 2015

Sounds like a spark plug, then if its not that have the battery checked.

Grizzly Big Bear... | Answered on Apr 08, 2015

Since it's a 2014, contact a Yamaha dealer.

2014 SR Viper... | Answered on Feb 21, 2015

It's an xt600 engine with 1 cylinder so 1 spark plug, remove seat & fuel tank

Yamaha Vehicle... | Answered on Feb 16, 2015

It is located on the left frame rail below engine at front behind lower control arm...

Bruin Kodiac Atv... | Answered on Nov 28, 2014

Just raise the seat and find the relay located next to the battery, remove the to nuts holding the wires on and unplug the small harness, install new one and replace the seat

Grizzly Big Bear... | Answered on Oct 06, 2014

power to switch then from switch to horn other side needs to be grounded usually marked pos neg

Grizzly Big Bear... | Answered on Sep 07, 2014

Is there a separate fuse for the brake - tail light

Grizzly Big Bear... | Answered on Aug 14, 2014

doesnt it have an oil tank and pump and manage its own mixing?

2-cycle Engine... | Answered on Aug 09, 2014

Halfords is a good place to go or your local independant motor mechanic

Grizzly Big Bear... | Answered on Jul 25, 2014

Will it not go into park or will the light not come on? If it goes into park look at the switch.
Check and make sure there is nothing binding the shift linkage or that the linkage is not bent. If all looks good adjust it.
Adjust your shift linkage just enough for it to go into park. Then check engagement in other positions

Grizzly Big Bear... | Answered on May 16, 2014

IAT stands for intake air temperature, the sensor is going to be located in the air snorkel tube/box air cleaner or the tube before the carb/throttle body (usually has 3 wires, reference voltage, ground, sensor output)

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/mike_a0891ab86974ea74

Grizzly Big Bear... | Answered on May 14, 2014

Did you check the battery itself? It could be a dead cell or even a defective one. Hope this helps, when you get it figured out let me know please. Good luck!

If you need further help, reach me via phone at https://www.6ya.com/expert/andrew_d2df42288260d96e

Grizzly Big Bear... | Answered on Apr 25, 2014

sounds like a relay getting hot

Grizzly Big Bear... | Answered on Apr 05, 2014

Not finding what you are looking for?
Vehicle Parts & Accessories Logo

Popular Products:

3 questions posted

Ask a Question

Usually answered in minutes!

Top Yamaha Vehicle Parts & Accessories Experts

Andrew Taylor
Andrew Taylor

Level 3 Expert

23620 Answers


Level 2 Expert

439 Answers

Jeff Youtsey
Jeff Youtsey

Level 2 Expert

109 Answers

Are you a Yamaha Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Yamaha Vehicle Parts & Accessories

  • Forum

View Most Popular

  • Yamaha Vehicle Parts & Accessories