Whynter Water Filters & Coolers - Recent Questions, Troubleshooting & Support

unplug for couple of minutes for thermostat to reset then plug it back

check control setting

The heating and cooling sections are separate..these are not known to last very long. Sorry. (check the switches though - does the indicater light come on?)

Try to find them here Find the low cost Wholesalers Dropshippers on biggest wholesale place. Best of luck

Contact customer service and beg and plead. If that fails threaten and insult, crying sometimes adds the pity factor and if that fails log into your account and change all your data to false information! :-)

It is probably a faulty valve..

Slight boiling noise aside, a loud and unbearable rattling noise plagued my B&D Hot and Cold Water Cooler (top load). DIY Solution: The issue was some sort of copper coil vibrating against the front panel cover (just behind where you would place a glass. This copper colored coil is attached a canister looking thingy ma-bob, with a long black arm that is runs to the bottom right of the back cover. By removing all four screws on the back cover, you may angle (bottom out) the cover enough to gain access to this arm. GENTLY... lift the arm/rod so that the copper coil is no longer touching the front panel (and thus it is free to vibrate without that annoying noise). CAUTION: unplug the unit and ground yourself to avoid shock. Once you can see the coil is no longer touching, plug-er back in and see if the noise has stopped. Perform above at own risk.!!!!!

I have the YLR2-5-96H2 and hot water stopped heating up. I unscrewed the casing and unplugged the connections to the circular heating element and 2 circular probes. Brushed off the white dust build up on the probes and it started to heat water again. I ruled out faulty heating element, because it got really hot just seconds after turning on the hot water switch.

Check power to relay. If yes, check compressor is working. If yes, keep your hand on discharge pipe. If it's not warm, cooler is under gas leak. Rectify leak and recharge gas.Thanks.

why are the car looking at me?

i have problems with hot water, the handle is broken
YLR2-%-24H2

my hot water faucet is broken!!.. when can i get new?

water leak from inside the refrigerator

call primo water corp. for parts!
866-429-7566

I need to do the same thing. Please let me know if you were able to get this done. It would help me out alot. Thanks you.

i am having the same problem and i lost the model number for it but can you please share the modle number if you have it because i call sunbeam and they need it so they can find it for me! thaky e mail @ [email protected]

Hi.

The only manual available is the one for the new 7SB series. The manual and the dispensers are practically the same. Please download the manual here: FX-7SB user manual

The manual for FX-6SB can only be obtained contacting Whynter: Phone: 866-WHYNTER Email:[email protected]

solution

RUN THE MODEL NUMBER ON THE SEARS SITE. YOU MAY GET AN ILLISTRATED PARTS BREAK DOWN AND BE ABLE TO ORDER THE PARTS. http://www.searspartsdirect.com/partsdirect/index.action

i think it may be two option either your heater thermostate switch ,heater timer aren't working or it has a problem of the water. check the tds of the water.or you should check the heater capicity as well as set the water heating temp.