Weber Grilling - Popular Questions, Answers, Tips & Manuals


After making sure your knobs are installed properly examine the full length of all burner tubes. You will be looking for areas of corrosion or damaged metal. Holes that are larger than they should be will cause too much LP expulsion resulting higher temperatures. Replacement parts, schematics, customer support and much more is available at the official Weber site. https://www.weber.com

Weber Grilling | 151 views | 0 helpful votes


Did you check round the burner control knobs

Weber Spirit... | 101 views | 0 helpful votes


does it have a battery
most cookers are pizo operation which operates by the button being pushed action

Weber Spirit?... | 246 views | 0 helpful votes


It depends on which model you have as there are numerous different designs going back decades.
So please indicate the model, the location of the knob in question and posting a picture would also be handy.

Weber Grilling | 147 views | 0 helpful votes


It could be a partially blocked gas jet or insufficient gas pressure is reaching the jet.

Clearly the pipes and valve should be checked if cleaning the jet doesn't provide a cure.
It is a good idea to compare the jet size and air bleed size with specifications. If it is set up for propane and being used with butane it will display the inefficiency you described.

There have been a few appliances designed for use with bottled gas that weren't intended to be used with a pressure regulator and lots of propane appliances that need a higher pressure than the standard fixed regulator can supply and an adjustable regulator should be used instead.

Weber Genesis... | 210 views | 0 helpful votes


how did you put on with screws or just push in a hole . THINK and OPEN you eyes

Weber Genesis... | 183 views | 0 helpful votes


Nice unit. I was looking at it last night in Home Depot.

http://www.weber.com/grills/series/summit/summit-s-470

Should spark ignite like the burners surely? Perhaps the igniter post needs adjusting, or a lead has become disconnected?

Weber Summit... | 258 views | 0 helpful votes


Check the switch with the wires disconnected from the board with an ohm meter. There should be NO continuity when the button is not pressed. If there is , replace the switch. If it checks OK then replace the board.

Weber Spirit?... | 192 views | 0 helpful votes


I've been in the propane business 28 years and have found regulators from the 1950's still in use today. Regulator manufacturers tell us they should be replaced after 25 years. It should typically outlast the grill itself, which often require new burners, cooking grids, etc. The hissing sound can just be the flow of gas thru the regulator. If you smell gas however, then you should replace it. If it is affecting the pressure to the burners and not getting hot enough to cook properly, then replace it as well.

Weber Genesis... | 398 views | 1 helpful votes


Some tips here

Weber com Support Help Grilling Tips


You can ask them for manual


Weber com Support Manuals



Some tips for smpking


Top Ten Tips for Smoking




The Best Setup for a Weber Smokey Mountain Barbecue Smoker and Other Bullet Shaped Charcoal Smokers
amazingribs com




Watch this video


Weber Grills Smoking on Your Smoker

Weber Grilling | 170 views | 0 helpful votes


Be sure the valve on the tank is open. Be sure the gas line is screwed on correctly and on tight enough. Be sure the battery in the starter is OK.

Weber Grilling | 172 views | 0 helpful votes


if you got the cannister from the shop with the grill the chances are that the cannister needs filling first as gas bottles are empty when new.

Weber Baby Q... | 252 views | 0 helpful votes


The burner has a fixed orifice, but there may be an adjustable air shutter (to adjust more or less air) at the end of the venturi tube that inserts over the orifice. If not, also try removing the gas valve knob and see if there is a small screw inside the shaft that you can adjust the flames. Most stoves have these. Also be sure the burner hasn't been spilled on. it may just need to be cleaned for a proper flame.

Weber Genesis... | 227 views | 0 helpful votes


There are several videos on this on youtube. To remove the side tables watch this video at about 15 minutes in it will show you how to install. Reverse is easy. Press outward on the outside arms, press upward on table an it pops up, then slide table back towards grill an remove.
Weber Q3200 with Permanent Cart Assembly Guide

Weber Grilling | 195 views | 0 helpful votes

Not finding what you are looking for?
Weber Logo

1,520 questions posted

Ask a Question

Usually answered in minutes!

Top Weber Grilling Experts

paulcarew

Level 3 Expert

2264 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

yadayada
yadayada

Level 3 Expert

68970 Answers

Are you a Weber Grilling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...