Waterway Pool & Spa - Recent Questions, Troubleshooting & Support

RV water lines can sometimes be difficult to locate. But typically, by removing a panel or an accessible flooring section, Youcan successfully gain access to most of the fresh water plumbing system. The clue to a removable panel is to look for screws instead of staples holding them in place

To remove the impeller you first take the front face plate off to expose the impeller. Then isolate the shaft from the motor with a pair of needle nose vise grips and using a pair of channel lock pliers grip the end of the impeller and rotate counter clockwise to un thread it from the shaft. If the shaft seal has been leaking there may be to much corrosion to turn the impeller in which case it needs to be broken off.

If the pump is getting hot check the voltage to make sure it is within 10% if it is it is a bad pump if it is not bad gfi

switch of the power and isolate the power cord. To uninstall unthread the two inch discharge port union,then the 1.5 intake port union.

perhaps you should take it to motor shop ( google motor rewind and repair in your area).. Electrical motors that run in water should be repaired by insured shop.

There is no fuse in the pump itself. Pump fuses are located in the control pak where the pump cord is attached. Turn off the power to the spa and remove the cover of the pak. There is usually a diagram of the board showing where the fuses are. Pump fuses are not clear they are about 1 1/4" long and have a label on them with the rating of the fuse. Usually 20 or 25 amps and either SC or AG rating

reposition the 3 way tap for the sand filter

The pump motor should have a label on the side of the motor showing a diagram for Common, High speed, Low speed and the right positions for the connections. Common is always the white wire High speed is normally red Low speed is Black Green wire is always green

Replace the grids