Velodyne Audio Players & Recorders - Recent Questions, Troubleshooting & Support

Hi,the transistor that controls the sub-woofer inside the speaker is bad and needs to be replaced for the sub-woofer to start working again.

There is a unit inside the speaker called a crossover unit. There are IC on it and transistors that controls the high frequency. Get a meter and read the transistor (it is usually colorful), and check which is bad and replaced .

Take care.

Already answered for DPS-12 in 2011 which suggests a fuse where the power enters, However, your manual mentions no fuse, but 'protection circuitry'. If there is a fuse, it will be inside and on a circuit board. All fuses have the rating on the end cap of glass fuses and on the side of ceramic fuses, which as also colour coded. https://velodyneacoustics.com/pdf/vx-11/VX-11Manual.pdf

Where to find fuse on velodyne vx-10b - Fixya

www.fixya.com > ... > Velodyne > VX-10 Subwoofer

Sep. 11, 2011 - where to find fuse on velodyne vx-10b - Velodyne VX-10 Subwoofer. ... in the manual shows a fuse rating of 2 amps where the power cord enters the box. ... here's a link to the owner's manual: http://velodyne.com/vx-11.html.

It sounds like you may have ripped the passive (the rubber material around the speaker that stretches when the speaker hits. If the passive is not ripped then it may be picking up static, or it could be blown. You can purchase a noise filter fairly cheap and try that.

Request schematic from manufacturer

You need to remove 12 outer screws, then remove the amp it might be held in with gasket.

There is a repair shop Edwards Electronics they are master's at repair. They are on web and eBay.

Sounds like you will need a new amp. Please send your serial number and the complete model number if it is different and I will quote a repair. [email protected]

Replace all the greatest sized capacitors inside are deformed or leaking. can be a 6 pieces because some of them are used parrallell to get double capacity.