Troy Heavy Machinery - Recent Questions, Troubleshooting & Support


There should have been a separate manual for the Brigg's and Stratton engine that accompanied the user manual. That engine manual addresses oil and gas. I also suspect that the model number is 4265. At any rate, if there is no dip stick, it is likely you want the oil to the top of the fill hole. You can check by phone or chat the support for the chipper shredder if this has not assisted you. Click the link below.

http://www.troybilt.com/webapp/wcs/stores/servlet/DisplayOwnersManualList?storeId=10001&catalogId=14102&langId=-1&logoCode=02&modelNumber=CR4265&serialNumber=

Troy Heavy... | Answered on Jun 16, 2018


Probably need to sharpen blades.

Troy Heavy... | Answered on Nov 20, 2017


Best Manuals Try it here, mate. I'm pretty sure they must be having

Troy Heavy... | Answered on Nov 09, 2017


Give this a try -
manualagent.com/troy-bilt/cs-4325-chipper-shredder/owners-manual

Troy Heavy... | Answered on Sep 13, 2017


You obviously damages an electrical component in the mix when you reversed current polarity. Get a hold of a schematic and check out what you may have damaged. If there is some sort of electronics that is a good place to start since you have no spark. I would check out the ignition circuit first.

Troy-Bilt®... | Answered on Aug 27, 2017


take the line of the carby and check the fuel flow first
indicates that the carby is not filling ( jammed needle and seat) or the main jet is blocked

Troy Heavy... | Answered on Jun 29, 2017


Request the manual directly from Troy Bilt

Troy Heavy... | Answered on May 25, 2017


there is either a clip or a cotter pin that needs removed , then slide the wheel off .

Troy-Bilt®... | Answered on Jun 28, 2016


How old is the fuel in the tank and also look into the tank for water from condensation. If the gas is older than 2 months drain the tank and the carb bowel.

Troy Heavy... | Answered on Mar 22, 2016


i NEED A REPLACEMENT VACUUM SNOUT FOR A 1990 TROY BILT CHIPPER-VAC. THERE IS NO MODEL NUMBER FOR THAT YEAR, ONLY DESIGNATED AS "MODEL 5 HP".

Troy Bilt Walk... | Answered on Feb 21, 2016


Clean the bowl under carb,theirs a nut at the bottom holding it ,pinch your gas line so gas won't come out.remove gas and reinstall.

Troy Heavy... | Answered on May 25, 2015


Call Fred at 651-786-4277 I have many new and used parts for your model

Troy Heavy... | Answered on Dec 26, 2014


I own one of those, assume it's the same model. I'd go to the B&S carb page. If that doesn't help, you can contact them. https://www.briggsandstratton.com/eu/en/support/faqs/adjusting-the-carburetor

Troy Bilt Walk... | Answered on Jun 10, 2014

Not finding what you are looking for?
Troy Logo

123 questions posted

Ask a Question

Usually answered in minutes!

Top Troy Heavy Machinery Experts

Matt Olenzek
Matt Olenzek

Level 2 Expert

297 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Wade Mobley
Wade Mobley

Level 3 Expert

513 Answers

Are you a Troy Heavy Machinery Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...