Sony ES - Recent Questions, Troubleshooting & Support

Sir pleas press menu +setup+factory setup and set turn restart and then select every thing again please take care when set asked home mode or shop mode select home mode at that time

Man thats horrible did this start happening when it was first hung on the wall?

See if this helps... https://www.youtube.com/watch?v=xox5E_29rtM

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. Before going further; try a hard reset first. If it does not help you, replace the main digital board. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; visit the site linked here.

Your LCD or Control Board is damaged. You can replace the LCD or the Board or have someone do it for you.

If there is one left. Take it to a hardware and find one suitable. Or go to a TV repair and they can give you some. for a small fee. Hope that helps.

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/

It would probably cost more to fix than it would to buy a new one.

I have a tv sony lcd klv32bx300 when turning on works for about 15mins then sfhuting down and blinks 3times the red led on standby signal . Then stop for 2sec and again blinks 3times. I bought this tv in the middle east but we are h ere now in phils. I br ought this problem here in sony service center but the cost to repair this problem is half of the price when i bought. Any one can help to fix this problem

Cheapest way out.. Buy new monitor..

Replace entire monitor..Cheaper to by new..

It sounds like the LCD backlight is done for. You're going to have to take it in for service to get the backlight replaced.

picher is haf biad

screen problem