Sanyo Heating & Cooling - Recent Questions, Troubleshooting & Support


check the unit drain tube, missing or not connected correctly

Sanyo Heating &... | Answered on Sep 10, 2017


Recheck the wiring. Pay special attention to the wiring splices with those triangular doo dads on them.. that is where my issue was! Wires was just eaten away by the elements.

Sanyo Heating &... | Answered on Sep 09, 2017


Test remote with AM radio turned up full blast at 600 on AM dial. Any button you press should beep the radio. If not the remote is fubar.

Sanyo Heating &... | Answered on Sep 01, 2017


We recommend you get it serviced regularly by an air conditioning company.

You need to spray anti bacterial spray and change the filters to service your air con.

Sanyo Heating &... | Answered on Jul 20, 2017


Before connecting you should check the amperage of each ac then make total amps may the disconnect can not support

Sanyo Heating &... | Answered on Jan 02, 2017


some units my have the power save key or a button with a plug icon on it this will make it sort of "sleep" while it waits for the temp to get past a temp point before it turns its self on or off (sleep)

Sanyo Heating &... | Answered on Dec 05, 2016


That happened to us. It was a broken pump, pump was up in attic. attached to our inside air-con unit. We had it fitted on an inside wall of the house, and so a pump must be installed to take away the condensed water to the outside of the house. Hindsight being 20/20 I would never buy one that needed a pump to get the condensed water out of the house. We would have put it an outside wall where the water goes straight outside, no pump needed. Our First pump lasted just over 2 years so warranty was expired. Cost us over NZ$500 to have new pump installed. Never again. Only attach your unit to an outside wall, even it looks prettier on the wall where it would need a pump. Bottom line:- Don't touch a pump. Pump was cheap but labor cost for serviceman astronomical! Bet of luck.

Sanyo Split... | Answered on Nov 09, 2016


"Programming" is in the remote.

Sanyo... | Answered on Aug 02, 2016


The symbols show pictures of the function provided for more specific answer send a list of symbols on your unit .
Thanks,
Alex

Sanyo Split... | Answered on Jun 28, 2016


there is no suction at all when the machine is off as the gas equalizes around the system
all you will read is the pressure of the gas in the system and that will tell you nothing
to read gas pressures you need to know the type of gas in the system , have gauges that can handle the high pressures and have two on a manifold so that you can read suction and high side pressure differences
That way you can see if the system is low on gas or over charged

Sanyo Split... | Answered on Feb 24, 2016


need to know the gas in use as r12 pressures are lot less than r134

Sanyo Split... | Answered on Feb 22, 2016

Not finding what you are looking for?
Sanyo Logo

524 questions posted

Ask a Question

Usually answered in minutes!

Top Sanyo Heating & Cooling Experts

Donni Steen

Level 3 Expert

659 Answers

Dennis Boxerman

Level 3 Expert

1144 Answers

Tim Whalen

Level 3 Expert

3074 Answers

Are you a Sanyo Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...