RTO Boating - Recent Questions, Troubleshooting & Support

If it has the old points system you will need to set the points also adjust the carburatior screw the screws all the way in and back out 2 1/2 turns then get it to run turn the air mixture screws till it runs smooth. you want it slightly lean then enrichen it slightly, afterword shut the engine down and look at the plugs if they are gray black they are ok. good luck.

If the boat is Fiberglass, it can be repaired with fiberglass Matt and resin.

It depends on the material of the hull. If it is Fiberglass then buy a small auto or boat repair fibreglass kit and follow instructions in the kit.
. If it is one of the engineering thermoplastics like High density Polyethylene ABS or Polypropylene I would try and find somone who can weld it with the appropriate material. This would be done by carefully shaping the plastic away from the crack to form a "V" shaped recess and then filling the gap with the appropriate filler rod usually using a hot air blower designed for the job.

I used ABS, PVC combination plumbers glue, the kind they use to put plastic waste pipe together, to patch up 2 small holes in my plastic pelican boat. It seems to melt on, so far so good

We would recommend purchasing a new one. Outboard Parts Outboard Motor Parts All Brands

I think you are getting water in the oil from somewhere. I assume you mean in the bottom end gear case ?

AFAIK not much you can do with carbon, return to dealer or manufacturer.

Sounds like you have a serious drag or weight issue on the boat.Could also be the wrong propeller for the setup.If that is not it try cleaning carbs with seafoam and adding seafoam to fuel.