I have a Phoenix Gold Octane Amp and 10d
Ok, when you look at the amp, the power + and ground - will be on one side of the amp with another smaller opening in between them. That opening is for your remote wire from your radio. Without that, your amp will not receive the input voltage to signal it to turn on. The speakers will go into the remaining open holes. Your RCA wires will be on the opposite end of the amp.
Where are the fuse on this amp?
The Tantrum 1200.1 is externally fused -- there is no fuse within the unit. Per the installation guide, it should have an 80 amp fuse between the amp and the power source.
Can i bridge rsd60.1
Negative a any amp that is 60.1 or 1500.1 whatever it is .1 is a mono amp and needs no bridging. Some mono amps are set up like a 2 channel but they aren't bridgable they just add more options for wiring each individual sub to the amp...
Hi, I have a pair of RF prime 6x9s 60w rms, 48hz
Ok for best results.
1.make sure you agust the gain according to person prefrences.
2make sure you set the crossover on the amp.ok in your speakers the would probley sound best if you set the Low pass fillter at 50hz and the high pass fillter at 25khz (if you have one) or on your headunit
Hope this gets the results you want.
Alex
My phoenix gold qx 900.1 comes on but goes into
if your amp is not 1ohm stable you will continue to over load it on those kickers you need to take it easy man not go over board with those 15s get you like one 12 man in good box ported or sealed thats all you need man with that amp
Not finding what you are looking for?