Mowtownusa Electrical Supplies - Recent Questions, Troubleshooting & Support

Yes, right after the piston seizes in the cylinder. If the motor is still running but doesn't have a lot of power and smokes a lot, you are mixing too much oil in your gas. You should go for a 50 to 1 mix. Read the label on the two cycle oil bottle for the proper amount to use in your gas for this ratio.

In the off position it breaks the ground that is how it shut it down.

i have the exact same problem...anyone?

Ngk BR6S gapped at .030 inch.

The proper mix is 50:1. The link to the manual is
http://ourfamilys.deandrea.net/BobKitty/User%20Guides/tosnowss.pdf

The fuel mixtures can be found on page 11. Hope this helps.

KLHsdgkjHGSDUIOHEUIOH

should be in the engine manual

just take off the AIR filter and thar is a Big Hole thar spray sum starte fluid in the bigger hole and spray it for three sec then try an start it

check the belt there is a tensioner on mine the work to tighten the belt when you pull the handle there may be something in there that is not letting it release all the way

need a manul for a s-620 tora snow blower

go to toro.com

You should be able to get a manual at toro.com