Miele Dryers - Page 5 - Recent Questions, Troubleshooting & Support

Try not putting to many clothes in at once and see if that makes a difference .

The thermostat is jammed-located behind the rear central panel,
Remove the 4 screws and prise of panel to reveal the thermostatic switch which is held in by one screw and the heat element that is held in by metal tabs. Both these items have 2 wires attached. Unscrew thermostat and chuck it on the floor a few times to juggle and reset. Really. Replace and enjoy the heat back !

not safe to use will need an electrician not easy to get some parts for that model possibles plug to wall shorted internally older the dryer more reduction of wet clothes load required motor or bearings tired timer or heater element faulty safety door switch faulty

most likely you have a bad door switch your dryer will stop when the door is opened another way of by passing this switch would be to find it onthe inside of your dryer and connect the two wires together this is only a temporary fix your dryer would always run even withthe door open by doing this best thing to door is look online marone appliace call them give them your model number order a door switch ad you might even need a door latch also if your door is not staying closed hope this helps

The thermal fuse is round, and has two wires going to it. It can be located on the element housing itself, or on the rear bulkhead.

Well, no light, no run. Means no power. A voltmeter might be useful. Be careful!!! Pete

You can't figure out how to open the door. Really? Try harder. Pete

Sounds to me like a logic board problem. 24 H power down would have fixed any transient problems. So it is a hard failure This means a sensor, or a processor failure. I think it is a processor board. Good Luck, Pete