Medline Industries Health & Beauty - Recent Questions, Troubleshooting & Support
All prerssures taken with this
Recalibration must be done by the manufacturer. As they have to certify that it was calibration is correct. Most do no charge for this service. So, contact the manufacturer at their number in your Owner's Manual, to find out how they handle the return of the unit for recalibration.
7/12/2011 1:17:14 PM •
Medline...
•
Answered
on Jul 12, 2011
My Rascal 318 has two
Hi wrosser2
Two constant yellow flashing lights indicates three things
1. Low voltage. Load test your batteries even if they are new. You may need to take them out and charge them on a car charger. Your charger won't work without at least 20 - 22 volts. Your inhibitor on the charger won't close to make continuity to turn the charger on.
2. With an olms meter check your front to rear harness for continuity. If you have a bad wire, replace the front to rear harness.
3. Third and most costly is a bad controller. No way to check that without replacing it. Check 1 & 2 first.
Good Luck
mimobility
5/4/2011 6:25:23 PM •
Medline...
•
Answered
on May 04, 2011
Good Afternoon,
Regarding your Medline
You'll need to get that information directly from Medline, the manufacturer.
If you live in the US call 800-633-5463
In Canada call 800-396-6996
In Mexico call 01-800-0898
3/18/2011 3:23:39 PM •
Medline...
•
Answered
on Mar 18, 2011
No meds coming out of
Make sure that the line is cleared and going from the little are you put it into to the full mask into the mouth. Also, make sure you use cold water to clean the unit and never use soap to clean it, that will breakdown the chemicals for the Neb machine. Take care...
9/10/2010 4:08:49 PM •
Medline...
•
Answered
on Sep 10, 2010
Wheel locks will not hold.
hi, if i remember right, have these got and adjustable nut and bolt that you can undo the nut adjust the bolt then do the nut up again to lock the bolt, if it is, just wind back the bolt a tad a few turns, as it sounds like your locks are adjusted to tight, so if you can just adjust the nut and bolt, if its a bar type configuration, there may be the same sort of thing on that at one end, just do the same, loosen it off, obviously if that still does the same thing, try adjusting it the other way just to see, but it is showing all the signs of being too tight and not to loose hope this helps please rate and vote thanks
8/26/2010 8:36:30 AM •
Medline...
•
Answered
on Aug 26, 2010
I have a medline b/p
The cuff sensor must be placed directly over the vain. This takes a little practice
2/6/2009 1:34:36 PM •
Medline...
•
Answered
on Feb 06, 2009
Sphygmomanometer
most likely when you dropped it on the concrete floor the compact of it hitting the floor has either jarred something on the inside of it and has caused it to not work properly or find the papers to the machine and restart the directions for it. i hope that something i have said may work, good luck!
1/24/2009 6:57:15 PM •
Medline...
•
Answered
on Jan 24, 2009
How often should I visit my dentist?
Most adult and children visit the dentist for regular
checkups and cleanings every six months. People at greater risk should have
checkups more often.
Not finding what you are looking for?